Starting up the machine (fig.5-6)
Turn the main switch to the ‘1’ position.
Make sure the brake release switch is set at the ‘close position’ in order to be able to start up
the machine.
Set the selector switch at saw or spindle or jointer, and push the green start button.
Check the direction of rotation of the spindle!
Warning:
When starting up a single phase machine, turn the starter switch and hold untill the motor has
gained its full speed, and then let the switch loose, it will go back in the initial position.
All motors are protected against overload, when one of the motors has been shut down by the
overload protection, it is necessary to wait a few minutes untill the overload has cooled down.
To stop the motor; push the red ‘STOP’ button.
fig.5
fig.6
Selector switch
Brake release switch :
Brake in function
START button
Emergency STOP button
START switch single phase
Brake open
Not possible to start motor
