Adjusting the spindle height (fig. 18)
- Unlock the locking lever (4) by turning it to the left.
- Now the spindle arbor can be raised or lowered using the handwheel (5). Please note
that one turn equals 4 mm height adjustment of the arbor.
- After height adjustment always secure the spindle arbor by locking the lever (4) by turning it
to the right.
- When, after intensive use of the locking lever (4), it is no longer possible to lock this
lever, take off the nut (6) and remove the lever. Then turn it 1/6 to the left before
putting it back on again. Put the nut (6) back on and tighten it.
fig.18
The spindle fence and woodpushers (fig. 19)
The spindle fence is fitted onto the table with two threaded knobs.
By loosening these two knobs, the complete fence can be slid to the front and back in the two
slots.
The fence plates should always be set as close as possible to the outer tool diameter. The
depth of the back fence can be set and adjusted with the knob (4). To align both fences a very
precise, straight edge should be held against the fences and the back fence alignment, adjusted
in such a way that there is no gap left between both fences.
Before starting any work always make sure that all knobs and clamps are correctly locked.
Never operate the spindle-moulder without using the woodpusher safety device or a
feeder.
fig.19
Handwheel and locking lever
Spindle arbor locking handle
Locking knobs
Fence adjuster knob
Fence plate
