Bedienungsanleitung Robomow RL serie (Seite 13 von 84) (Englisch)

512470

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Chapter 1-1

Planning

Chapter 1 Planning

Before starting the setup, please read this chapter fully and watch the setup

DVD. This will help you determine the best location for the Base Station































, for the perimeter wire layout, or for the perimeter switch.

1.1 Determine Base Station location

Robomow’s Base Station is placed along the Perimeter Wire. This is where

the wire “loop” starts and ends. The Base Station has two main functions:

● It generates a small signal along the perimeter wire (very low voltage),

which serves as an “invisible wall” setting the lawn boundaries for

Robomow.

● It charges Robomow’s batteries.

After completing the one-time set-up of the Perimeter Wire and the Base Station,

a weekly program is set. That’s when Robomow does your mowing for the entire

season!

Robomow leaves the Base Station on the day and time scheduled in the automatic

weekly program. It mows the lawn and it returns to the Base Station for recharging.

First, you decide where the Base Station will be placed…

Q Inside the lawn area, along its outer edge.

Or:

Q Outside the lawn area

1.1.1 Consider the following in order to

choose the best location:

P If the lawn has more than one zone, set the Base

Station within the largest plot or zone.

P Make the Base Station invisible to the street.

P Prefer a shady spot.

This will extend battery lifetime

P Place the Base Station on a relatively level ground.

P Do NOT place it on a slope.

P Place the Base Station at least 1 meter from corners.

P Place the Base Station away from sprinkler heads.

Water or rain does not harm Robomow. However, we

recommend a distance from sprinklers for maximum protection.

1.1.2 If Base Station is to be located outside the lawn area

External setup of the Base Station allows the Base Station to be located

outside the lawn area, close to its edge.

Consider the following in order to choose the best external

location:

P Choose a place close to the lawn edge.

P The passing between the lawn and the Base Station

should be smooth, with no height differences.

This will enable Robomow to follow the wire smoothly to its Base

Station.

P The surface of the external area should be hard (e.g. a

sidewalk, firm ground). It should not be sandy or stony.

This will prevent Robomow from slipping or getting stuck.































Option A - Internal setup

(Inside the lawn along the outer edge)

Base

Zone

Base Zone

Base Station

Zone A

Base Station

Option B - External setup

(Outside the lawn)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Robomow RL serie Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Robomow RL serie

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info