P Trim the end without the connector to make both of equal length. Remove
any excess wire and strip back 5 mm (1/4 inches) of insulation from the
wire end.
P Insert the end
of the wire without the connector into the hole of the
other wire’s connector. Use a small flat screwdriver to tighten and
secure this wire into the connector.
2.6 Assembling the Base Station
2.6.1 Laying and fastening power cord
Safety – Avoid injury!
The Extension Cable should be securely fastened to the ground!
It should never present a tripping hazard.
The power cord should cross over soft surfaces ONLY. It should not cross
over hard surfaces (e.g. sidewalk, driveway) where it cannot be securely
fastened.
2.6.2 Base Station Assembly
2.6.3 Base Station Head and Base:
P Remove the Base Station Head from the Base.
Electric Shock Hazard!
Disconnect the Power Box from the plug socket before any approach to the Base
Station charging contacts (pins).
) Pull the lever (A) upward
) Push the Base Station head from the front side in the
direction marked B.
The head will slide out.
