Bedienungsanleitung Rotel rdv 1080 (Seite 27 von 28) (Englisch)

139017

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

English

Troubleshooting

If you are experiencing difficulties, consult the

following list for possible solutions:

No Power: make sure the unit is plugged

in properly.

Remote does not work: check the bat-

tery installation, install new batteries, aim

remote at unit.

TV/VIDEO-CANCEL, CURSOR, or NU-

MERIC buttons do not work: TV-DVD

switch must be set to TV to operate the TV

functions and DVD to operate the RDV-1080.

No picture: check the video cable connec-

tion and input setting on TV, turn off Progres-

sive scan feature.

Picture is noisy: do not connect unit directly

to VCR (copyguard feature may disrupt video

signal), turn off Progressive scan feature or set

its mode to VIDEO.

Picture is garbled: Change Screen Saver

mode to something other than Mode 1.

Picture does not fill screen: Set TV Monitor

type correctly.

No sound: check the audio cable connec-

tion and input settings preamplifier.

Garbled sound: Clean the disc surface.

Unit does not operate properly: To re-

set the microprocessor, turn off the power,

unplug the power cord, and reconnect the

power cord. Following a sudden temperature

change (such as bringing unit or discs inside

from extreme cold), allow several hours for

possible condensation to clear.

Specifications

General

Readable discs:

DVD Audio, DVD Video, Audio CD,

Video CD, SVCD

Video format:

For NTSC discs, the scanning mode can be selected

between Interlaced scan and Progressive scan. For

PAL discs, only the interlaced scan mode is avail-

able.

Other

Power requirements:

AC 110-240 V , 50/60 Hz

Power consumption:

20 W (POWER ON)

1.5 W (STANDBY mode)

Weight:

5.1 kg (11.2 lbs)

Dimensions (W x H x D):

430 mm x 121 mm x 340 mm

16-

15/16 inch x 4-13/16 inch x 13-7/16 inch

Video output

COMPONENT (pin jack):

Y Output: 1.0 Vp-p (75 ohm)

PB/PR Output: 0.7 Vp-p (75 ohm)

VIDEO OUT (pin jack):

1.0 Vp-p (75 ohm)

S-VIDEO OUT (S jack):

Y Output: 1.0 Vp-p (75 ohm)

C Output (NTSC): 286 mVp-p (ohm)

C Output (PAL): 300 mVp-p (75 ohm)

Horizontal resolution:

500 Lines

Signal to noise ratio:

65 dB

Audio output

Analog Out (pin jack):

2.0 Vrms (10 k ohm)

Digital Out:

Optical: –21dBm to –15dBm (Peak)

Coaxial: 0.5 Vp-p (75 ohm)

Audio characteristics

Frequency response:

CD (at 44.1 kHz): 2 Hz to 20 kHz

DVD (at 48 kHz): 2 Hz to 22 kHz

DVD (at 96/88.2 kHz): 2 Hz to 44 kHz

DVD (at 192/176.4 kHz) : 2 Hz to 88 kHz

Dynamic range:

16 bit: more than 100 dB

20 bit: more than 110 dB

24 bit: more than 110 dB

Wow and flutter:

Unmeasurable (less than ± 0.002%)

Total harmonic distortion:

16 bit: less than 0.0018%

20/24 bit: less than 0.0012%

All specifications are accurate at the time of

printing.

Rotel reserves the right to make improvements

without notice.

Rotel and the Rotel HiFi logo are registered

trademarks of The Rotel Co, Ltd., Tokyo, Japan.

DTS is a registered trademark of Digital Theater

Systems.

Manufactured under license from Dolby Laborato-

ries Licensing Corporation. “Dolby”, “Pro Logic”,

“Dolby Surround”, “Dolby Digital”, and the

double-D symbol are trademarks of Dolby

Laboratories Licensing Corporation. Confidential

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rotel rdv 1080 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info