6
GENERAL WARNINGS
The tool must be connected to a suitable dust extraction system (not supplied).
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in the “SAFETY INSTRUC-
TION” booklet which forms an integral part of these documents; the operating instructions
indicate the additional information required specifically for use of the tool. Never use the
tools without the safety guards. Any operations carried out on the tool must be effected with
the tool disconnected. Before starting the tool, ensure that it is held tightly and not in
contact with the work surface. The electric tool must be connect to a suitable dust extrac-
tion unit and applicable safety regulations must be observed if dusts dangerous to health
are likely to occur during sanding. Due to risks that may arise during sanding, we recom-
mend the constant use of P.S.D. (personal safety devices such as gloves, headphones,
goggles, face masks, etc.) according to laws in force to prevent or reduce accident proba-
bility.
Warning! Carry out the lubrication process outlined on page 7, in the maintenance
paragraph. The appliance continues to work for a few seconds after it has been swit-
ched off.
CORRECT USAGE
The sanders are designed for sanding wood, plastic, composite materials, paint/varnish, fil-
ling material and similar materials. Metal and materials with an asbestos content must not
be processed with these tools. The tools must not be damp nor operated in a damp envi-
ronment for electrical safety reasons. The tools may only be used for dry sanding. Make
sure the work piece is sufficiently fastened. In the event of improper use, the user is fully
liable for any damages or accidents.
PARTS OF THE TOOL
1 - On/off switch
2 - Tool body
3 - Compressed air connection with 1/4” thread
4 - Polishing pad (not supplied)
5 - Speed control
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been damaged during sto-
rage or transport;
- the tool is complete; check that the number and type of components comply with that re-
ported in this instruction booklet;
- the available compressed air production and distribution plant is capable of satisfying the
requirements reported on the tool’s identification plate reproduced and explained on
page 7.
ASSEMBLING THE TOOL
Assemble the compressed air connection (not supplied) by screwing it into its seating (3).
COMPRESSED AIR CONNECTION
The tool is supplied without the compressed air connection. The user can use either a quick
release coupling: or hose type connection according to his needs purke that have an hole
air passing mm 8.
ASSEMBLING THE POLISHING PAD
Screw the buffer pad on the spindle
Press the polishing pad to attach it to the back-up pad.
BEFORE STARTING THE TOOL
Ensure that:
- the compressed air feed line and connection are in perfect working order;
- the start lever is working properly. This must be done with the air supply switched off;
- all the components of the tool are mounted correctly and do not show any signs of da-
mage.
STARTING AND STOPPING
- Starting: push the control lever (5) forward towards the body ofthe tool and keep it pressed.
- Stopping: release the control lever.
TEST RUN
Start the tool and check that there are no unusual vibration, or dismatching of disc pad with
polishing pad. Otherwise switch-off the tool immediately and eliminate the cause.
6
TYPE LH75P
WORKING PRESSURE bar 6
AIR CONSUPTION l/min 500
ROTATION min 4000
DISC DIAMETER mm 75
WEIGHT Kg 1,000
TECHNICAL DATA ENGLISH
