Bedienungsanleitung Ryobi PPW-3000 (Seite 27 von 309) (Alle Sprachen)

557213

Zoom out

Zoom in

Vorherige Seite

1/309

Nächste Seite

OPERATION

■ Flush for 1 - 2 minutes (spray clear water through the

spray wand).

■ Shut off the engine.

NOTE: Shutting OFF ( O ) the engine will not relieve

pressure in the system. Pull trigger to release water

pressure.

RINSING WITH THE PRESSURE WASHER

■ Turn off the pressure washer and shut off the water

supply. Pull trigger to release water pressure.

■ Engage the lock out on the wand by pushing up on

the lock out until it clicks into the slot.

■ Pull back and hold the collar.

■ Remove the nozzle by pulling it from the collar.

■ Select the right nozzle for the job:

• Use lower pressure nozzle (white or green) to wash

items such as a car or boat.

• Use higher pressure nozzle (yellow or red) for jobs

such as stripping paint and degreasing the

driveway. When using these nozzles, test a small

area first to avoid surface damage.

■ Start at the top of the area to be rinsed and work

down overlapping the strokes.

MAINTENANCE

WARNING:

When servicing, use only identical replacement

parts. Use of any other parts may create a

hazard or cause product damage.

WARNING:

Always wear safety goggles or safety glasses

with side shields during power tool operation or

when blowing dust. If operation is dusty, also

wear a dust mask.

WARNING:

Before inspecting, cleaning or servicing the

machine, shut off engine, wait for all moving

parts to stop, and disconnect spark plug wire and

move it away from spark plug. Failure to follow

these instructions can result in serious personal

injury or property damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline,

petroleum-based products, penetrating oils, etc.,

come in contact with plastic parts. Chemicals can

damage, weaken ordestroy plastic which may

result in serious personal injury.

Before running the engine, perform the following pre-

operation steps:

■ Check that all bolts, nuts, etc. are securely tightened.

■ Make sure the air filter (43) is clean.

■ Check both the engine oil level and the fuel tank

level; refill as needed.

■ Inspect the work area for hazards.

■ If there is excessive noise or vibration, stop the unit

immediately.

CLEANING THE AIR FILTER

( Fig.18)

A dirty air filter will cause starting difficulty, loss of

performance, and shorten the life span of the engine.

Check the air filter monthly. If working in dusty soil, clean

the air filter after each refueling. For best performance,

replace the air filter at least once a year.

To clean the air filter:

■ Remove the cover (42).

■ Lift the edge of the air filter carefully and pull it out.

■ Wash the air filter with warm, soapy water.

■ Rinse and squeeze to dry.

■ Put small amount of 30 wt. motor oil on the filter

sponge. Squeeze out the excess oil then reinstall the

air filter.

NOTE: Make sure the filter is seated properly inside

the cover. Installing the filter incorrectly will allow dirt

to enter the engine, causing rapid engine wear.

■ Reinstall the cover.

CHANGING THE ENGINE OIL

(Fig. 19)

■ Shut off the engine.

■ Place a container (45) under the pressure washer.

■ Remove the oil plug (46) and drain the old oil.

NOTE: Drain the oil while the engine is still warm but

not hot. Warm oil will drain quickly and more

completely.

■ Replace the oil plug.

■ Replace the oil with new, clean oil. This engine will

hold 0.6 litres of oil.

(Recommended 4-stroke engine oil: 10W30)

CHECKING A FOULED SPARK PLUG

( Fig. 20)

■ Clean off carbon deposits on the spark plug electrode

using a plug cleaner or wire brush.

■ Check electrode gap. The gap should be .6 mm-.7

mm. Adjust the gap, if necessary, by carefully bending

the side electrode.

English

F D E I P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT LV SK BG

PPW-3000_25lgs.qxd 3/26/01 11:52 PM Page 19

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ryobi PPW-3000 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info