Bedienungsanleitung Samsung NK86NOV9MSR (Seite 24 von 69) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

580859

Zoom out

Zoom in

Vorherige Seite

1/69

Nächste Seite

- 24 -

GENERAL

Carefully read the following important information regarding

installation safety and maintenance. Keep this information

booklet accessible for further consultations. The appliance

has been designed for use in the ducting version (air exhaust

to the outside – Fig.1B), ltering version (air circulation on

the inside – Fig.1A).

SAFETY PRECAUTION

Take care when the cooker hood is operating simultane-

ously with an open replace or burner that depend on the air

in the environment and are supplied by other than electrical

energy, as the cooker hood removes the air from the environ-

ment which a burner or replace need for combustion. The

negative pressure in the environment must not exceed 4Pa

(4x10-5 bar). Provide adequate ventilation in the environment

for a safe operation of the cooker hood.

Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity network:

- control the data plate (positioned inside the appliance)

to ascertain that the voltage and power correspond to the

network and the socket is suitable. If in doubt ask a qualied

electrician.

- If the power supply cable is damaged, it must be replaced

with another cable or a special assembly, which may be

obtained direct from the manufacturer or from the Technical

Assistance Centre.

- To connect the device to the power supply through a plug

with a 3A fuse or to the two wires of the two-phase protected

by a 3A fuse.

Warning !

In certain circumstances electrical appliances may be a

danger hazard.

A) Do not check the status of the filters while the cooker

hood is operating

B) Do not touch bulbs or adjacent areas, during or straight

after prolonged use of the lighting installation.

C) Flambè cooking is prohibited underneath the cooker

hood

D) Avoid free flame, as it is damaging for the filters and

a fire hazard

E) Constantly check food frying to avoid that the over-

heated oil may become a fire hazard

F) Disconnect the electrical plug prior to any mainte-

nance.

G) This appliance is not intended for use by young children

or infirm persons without supervision

H) Young children should be supervised to ensure they do

not play with the appliance

I) There shall be adequate ventilation of the room when

the rangehood is used at the same time as appliances

burning gas or other fuels

L) There is a risk of fire if cleaning is not carried out in

accordance with the instructions

This appliance conforms to the European Directive EC/2002/96,

Waste Electrical and Electronic Equipment (WEEE). By making

sure that this appliance is disposed of in a suitable manner, the

user is helping to prevent potential damage to the environ-

ment or to public health.

The symbol on the product or on the accompanying

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to

a suitable electric and electronic appliance recycling collec-

tion point. Follow local guidelines when disposing of waste.

For more information on the treatment, re-use and recycling

of this product, please contact your local authority, domestic

waste collection service or the shop where the appliance was

purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out

by specialised personnel.

• Electric Connection

The appliance has been manufactured as a class II, therefore

no earth cable is necessary.

The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load indi-

cated on the description label. Where a plug is provided, the

cooker hood must be installed in order that the plug is easily

accessible. An omnipolar switch with a minimum opening of

3mm between contacts, in line with the electrical load and

local standards, must be placed between the appliance and

the network in the case of direct connection to the electrical

network.

• The minimum distance between the support surfaces of

the cooking pots on the cooker top and the lowest part of

the cooker hood must be at least 45 cm. If a connection tube

composed of two parts is used, the upper part must be placed

outside the lower part. Do not connect the cooker hood ex-

haust to the same conductor used to circulate hot air or for

evacuating fumes from other appliances generated by other

than an electrical source.

- In the case of assembly of the appliance in the suction version

prepare the hole for evacuation of the air.

• We recommend the use of an air exhaust tube which has

the same diameter as the air exhaust outlet hole. If a pipe

with a smaller diameter is used, the eciency of the product

may be reduced and its operation may become noisier.

Attention!

• Before proceeding with the installation, to be able to move the

hood more easily, complete the following operations:

- Open the front panel of the hood as in Fig. 2 - stage 1.

- Remove the anti-grease lterl by pulling the handle, as shown

in Fig. 2 - stage 2.

Wall mounting

Trace the bottom side of the hood on the wall. Consider the

measurements shown in Fig. 3 and minimum distance from

the cooking surface.

- Mark and drill the holes, following the measurements

shown in Fig. 3.

- Fasten the 4 anchors A Fig. 3.

- Fasten bracket C to the wall using the 2 screws B Fig. 3.

ENGLISH

Samsung NK86NOV9MSR Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info