Bedienungsanleitung Samsung SNV-6085R (Seite 45 von 70) (Englisch)

621307

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

English _45

●● SETUP SCREEN

3. Click the [Test] button to see if you can successfully connect to the NAS.

If the success message is displayed, it means that you can successfully save data in the NAS.

If the fail message is displayed, check the following.

Confirm that the IP address of the NAS is valid.

Confirm that the ID/password of the NAS is valid.

Confirm that you can access the folder designated as the default folder using the ID of the NAS.

Confirm that the NAS SMB/CIFS items are unchecked.

Confirm that the NAS IP address and the camera IP address are in the same format.

ex) The NAS & camera subnet mask initial value is 255.255.255.0.

If the IP address is 192.168.20.32 then the NAS IP address should be in the range of 192.168.20.1~192.168.20.255.

Check whether you tried to access as another user without formatting the default folder saved or used.

Confirm that you used recommended NAS equipment.

4. After the settings are completed, set the NAS unit to <On>.

5. Click the [Apply (

)] button.

6. Log in the NAS and check the <Free size> and <Total size>.

You can format the default folder specified in the NAS connection setting by clicking the <Format> button.

Since data may not be saved after a temporary network interruption when using NAS, it is recommended that you use SD at the

same time to prevent loss of recorded images.

The data traffic will increase when the camera is set to higher resolution, higher bit rate, and/or higher framerate.

If there is too much data traffic, some frame may be skipped although it is stored in a full frame.

When a frame skip occurs, images are saved at the rate of min. one image per sec.

NAS (Network Attached Storage) guide

Since data may not be saved after a temporary network interruption when using NAS, it is recommended that you use SD at

the same time to prevent loss of recorded images.

If the setting allows a Micro SD memory card and the NAS to be simultaneously connected for use, the higher priority for

recording goes to the NAS.

If you activate Overwrite to the NAS by setting it to <Off> and the available capacity is below 1%, it will be saved in the Micro

SD card.

If you are saving data in the NAS, you might be unable to save it when you insert a Micro SD memory card used by another

camera.

NAS recommended specs : Refer to “NAS recommended specs”. (Page

)

If you change the NAS saving while saving data in the NAS, it will not be reflected in the system immediately.

If you remove NAS equipment on your own while saving data, or if the network is disconnected, NAS saving operation will be

terminated abnormally.

NAS saving allows only one camera to a folder. Logging in with another camera is not allowed, and the images will not be

saved.

The following is a description of how to save data using the NAS according to the Synology NAS method,

which is one of the recommended products.

1. Access the Synology NAS as an admin.

In this example, the NAS IP Address is set to

[192.168.20.253].

2. If you access it as an admin, the following screen will be

displayed. Click the [Control Panel].

3. Click the <Shared Folder> in the file sharing and privilege

menu.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung SNV-6085R Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info