Bedienungsanleitung Satel CA-10 (Seite 17 von 43) (Englisch)

699577

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

CA-10 Installer Manual 15

The control panel power supply is fitted with:

• battery status monitoring system with optional disconnection of discharged battery,

• visual signaling of the battery testing/charging process (LED indicator on the main board),

• changeover battery charging current (350 mA/700 mA).

The stabilized voltage of the control panel power supply is 13.6–13.8 V and is factory set.

Attention should be paid so as not to cause overloading of the control panel power supply in

the alarm system. It is advisable to make a load balance for the power supply. The total

current inputs for the consumers (detectors, keypads) and the battery charging current may

not exceed the power supply capacity. In case of a higher electric power demand,

an additional power supply can be used for some of the security system consumers

(e.g. APS-15, APS-30 manufactured by SATEL). Table 1 (at the end of this manual) shows

an example of estimated balance of current consumption by the system, and an example of

battery selection.

The CA-10 main board can be connected to an electric shock protection circuit (grounding).

The protective cable terminal is designated by the symbol.

The „neutral” wire of the 230 V AC mains supply must not be connected to the

grounding terminal. If the facility has no separate electric shock protection

circuit, this terminal must be left free.

The CA-10 control panel should be installed in an enclosed space with normal humidity of air.

The space should be fitted with an available permanent (not detachable) 230 V power supply

circuit with protective grounding.

The control panel can be mounted in the CA-10 OBU housing (this

housing comprises a transformer designed for operation with the

control panel power supply), which permits installation of a battery with

17 Ah capacity. Before the housing is secured to the base, it is

necessary to mount inside the housing plastic distance plugs, which are

intended for subsequent installation of the main board.

In case the plugs tend to slip out, the catches fixing the plug in the

housing need to be slightly bent aside (Figure 2). When inserting the

plug, press the central part of the head firmly in so that it is blocked in

the housing hole. It is advisable to make sure that the plug, when

pressed, does not slip out from the opening. During installation of the

housing, be careful so as not to damage the wires which will be passed

through the hole in its back panel.

When the housing is secured, you can install the control panel main board and proceed to

making the connections.

IMPORTANT: Do not connect the mains power supply and the battery, until all the remaining

connections are completed.

The control panel is power supplied from 230 V AC mains. Negligence or wrong

connection may result in electric shock and pose a threat to life!

Therefore, be particularly careful when hooking up the control panel. In the

process of installation and connection of the control panel, the cable to be used

for mains supply must not be alive!

Connection of keypads

The keypad is designed to operate indoors in normal humidity. It should be mounted straight

on a flat surface. The spring provided on the tamper contact must adhere to the base so that

the contact will open at an attempt to tear the keypad off the wall.

Figure 2.

PRESS IN

BEND ASIDE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel CA-10 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel CA-10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info