699391
8
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
6 INT-TSI SATEL
remember that CKM (clock) and DTM (data) signals must not be sent through one
twisted-pair cable. The wires must be run in one cable. The length of cables must not
exceed 300 m.
Fig. 4. Connection of the keypad to the control panel.
9. Connect the wires to the terminals of additional zones, if any detectors are to be
connected to them (the detectors are to be connected in the same way as to the control
panel onboard zones).
10. Connect the power supply wires to the keypad (terminals +12V and COM). The keypad
can be powered from the control panel mainboard, an expander with power supply or
from an additional power supply unit. The table below shows requirements regarding the
power wires (+12V and COM), if conductors with 0.5 mm diameter are used.
Distance from control panel
Number of parallel connected wires
up to 25 m 1
25 50 m 2
50 75 m 3
75 100 m
4
In the case of INTEGRA 24, INTEGRA 32 and INTEGRA 128-WRL control panels, the
+KPD output cannot be used to power the INT-TSI keypad. You should use the OUT1
or OUT2 high-current output, programmed as type 41. POWER SUPPLY.
A function is available in the keypad which makes it possible to check if the keypad
power supply is appropriate (see the INT-TSI keypad user manual).
11. If the keypad is to be connected to the Ethernet network (image from the network
cameras is to be displayed or the SLAVE keypad is to be used), connect the cable
terminated with RJ-45 plug to the dedicated socket. Use the cable compliant with the
100Base-TX standard (the same as used for connecting computer to the network). It is
advisable to use the flat network cable, which is more flexible, and secure the cable using
a cable tie (see Fig. 5).
12. Place the front panel onto the catches, snap close the enclosure.
After the first start-up of the keypad, downloading of the alarm system data from the
control panel will begin. It may last up to 20 minutes and make using the keypad
somewhat difficult during that time.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Satel INT-TSI-WSW wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Satel INT-TSI-WSW

Satel INT-TSI-WSW Installationsanweisung - Deutsch - 34 seiten

Satel INT-TSI-WSW Bedienungsanleitung - Englisch - 20 seiten

Satel INT-TSI-WSW Bedienungsanleitung - Englisch - 24 seiten

Satel INT-TSI-WSW Bedienungsanleitung - Holländisch - 20 seiten

Satel INT-TSI-WSW Installationsanweisung - Holländisch - 33 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info