699079
37
Zoom out
Zoom in
Vorherige Seite
1/114
Nächste Seite
SATEL INTEGRA 35
computer port to which the control panel is connected. Then, follow the procedure described
in section Starting the service mode “from pins”(p. 6).
Running the local programming from pins is not possible, if the DISABLE
DOWNLOADING option is enabled.
3.3.3 Finishing local programming
To end the local programming you can use the END DWNL-RS function ([service code]
DOWNLOADING END DWNL-RS).
The local programming function will be finished automatically after 255 minutes have elapsed
since the last use of the DLOADX program, and the service access was blocked or expired
during that time.
The local programming function must be disabled, if the control panel is to
communicate through the RS-232 port with an external analog modem, GSM module,
INT-GSM module or ETHM-1 / ETHM-1 Plus module (e.g. during remote
programming, event reporting, etc.).
3.4 Remote programming
3.4.1 Starting remote programming via modem
The control panel has a built-in 300 bps modem. The GSM communicator of
INTEGRA 128-WRL control panel supports sending data with the use of CSD technology, i.e.
at a rate of 9600 bps. In case of the other control panels, higher transmission rates can be
obtained after an external modem is connected. For information on how to connect the
external modem to the control panel please refer to the INSTALLER MANUAL. Initializing the
modem connection is possible, if there is a properly matched modem on the computer side
(see Table 4).
Configuration on control panel side Configuration on computer side
Built-in 300 bps modem Analog modem
External analog modem
Analog modem
GSM modem
External ISDN modem
ISDN modem
GSM modem
External or built-in GSM modem
Analog modem
GSM modem
Table 4. Selecting control panel and computer modems.
Communication can be established in several ways (shown in parentheses is information
about requirements on the control panel side):
1. Connection initialized from the DLOADX program (built-in modem 300 bps or external
analog modem). This method makes it possible to establish connection with the control
panel from any location. Establishing connection by this method is possible, if the
computer telephone number has not been programmed in the control panel.
2. Connection initialized from the DLOADX program, but the control panel calls back and
sets up the connection (built-in 300 bps modem or external analog modem). The control
panel may only be remotely programmed from a specified locality.
3. Connection initialized by means of SMS (INTEGRA 128-WRL control panel or SATEL
GSM module operating as an external modem).
37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Satel Integra 24 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Satel Integra 24

Satel Integra 24 Kurzanleitung - Deutsch - 2 seiten

Satel Integra 24 Bedienungsanleitung - Deutsch - 54 seiten

Satel Integra 24 Zusatzinformation - Deutsch - 121 seiten

Satel Integra 24 Installationsanweisung - Deutsch - 38 seiten

Satel Integra 24 Bedienungsanleitung - Englisch - 51 seiten

Satel Integra 24 Installationsanweisung - Englisch - 36 seiten

Satel Integra 24 Kurzanleitung - Holländisch - 24 seiten

Satel Integra 24 Bedienungsanleitung - Holländisch - 52 seiten

Satel Integra 24 Zusatzinformation - Holländisch - 121 seiten

Satel Integra 24 Installationsanweisung - Holländisch - 35 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info