Bedienungsanleitung Satel Integra 256 Plus (Seite 24 von 51) (Englisch)

699031

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

22 User Manual SATEL

Outputs control – allow to control the devices connected to the MONO SWITCH, BI SWITCH,

REMOTE SWITCH, SHUTTER UP and SHUTTER DOWN type outputs (see: “Outputs control”

p. 35).

Service mode – available to the installer. Initiates the service mode.

Take SM over – available to the installer. If the service mode has been initiated from another

keypad, it can be “taken over”, i.e. the service menu can be displayed on the keypad, on

which the TAKE SM OVER function has been started.

Downloading – the following functions are available in the submenu

Start DWNL-RS – available to the installer. Enables communication with the DLOADX

program through the RS-232 / USB port of the control panel (local programming).

Finish DWNL-RS – available to the installer. Disables the local programming of control

panel.

Start DWNL-MOD. – enables communication with the DLOADX program via the external

modem (analog, GSM or ISDN).

Start DWNL-TEL – enables communication with the DLOADX program via the 300 bps

modem.

ETHM-1 DLOADX – enables communication with the DLOADX program using the

ETHM-1 (firmware version 1.03 or newer) / ETHM-1 Plus module. The communication

takes place over Ethernet. If the INT-GSM module is connected to the ETHM-1 Plus

module and an attempt to establish communication via Ethernet fails, an attempt will be

made to establish communication via GPRS.

ETHM-1 GUARDX – enables communication with the GUARDX program using the

ETHM-1 (firmware version 1.03 or newer) / ETHM-1 Plus module. The communication

takes place over Ethernet. If the INT-GSM module is connected to the ETHM-1 Plus

module and an attempt to establish communication via Ethernet fails, an attempt will be

made to establish communication via GPRS.

INT-GSM DLOADX – enables communication with the DLOADX program using the

INT-GSM module. The communication takes place via GPRS.

INT-GSM GUARDX – enables communication with the GUARDX program using the

INT-GSM module. The communication takes place via GPRS.

5.4 Arming

This section describes the operations that must be carried out by the user from the keypad in

order to initiate the arming procedure. The arming procedure is ended at the running out of

the exit delay time (if the procedure is ended successfully, the system becomes armed – see

also “Failure of arming procedure” p. 24). If the exit delay time is 0, the system becomes

armed instantly.

The installer can configure the alarm system so that the arming functions will not be

available after tamper. A message on the display will indicate that the user must call

for service. The arming functions will not be available until the service code is entered

and confirmed with the key.

5.4.1 Full arming without partition selection

The arming without partition selection is possible when none of the partitions to which the

user has access is armed and the keypad is not signaling any alarm.

1. Enter the code and confirm with the

key

2. When the ARM ALL function is displayed, press the

key. The arming procedure will be

initiated in all partitions which are accessible to the user and are operated by the keypad.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Integra 256 Plus Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Integra 256 Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info