Bedienungsanleitung Satel Integra 64 (Seite 58 von 114) (Englisch)

699075

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

56 Programming SATEL

82. ARM/DISARM – the zone controls the arming status of the partition it belongs to.

The control mode depends on the CONTROL BY PULSE option. Disarming may

simultaneously clear the alarm and cancel the messaging.

83. CLEARING ALARM – violation of the zone will clear alarm in the selected group of partitions

(see: “Groups of partitions” p. 60) or the partition to which the zone belongs, and can also

cancel messaging.

84. GUARD – violation of the zone is recognized as recording the guard's round in the partition

to which the zone belongs.

85. ENTRY/EXIT – CONDITIONAL – similarly as the 0. ENTRY/EXIT type with an extra feature: the

zone becomes an instant one upon arming, if no partition exit is registered upon starting

the arming procedure.

86. ENTRY/EXIT – FINAL – similarly as the 0. ENTRY/EXIT, but the zone restore during exit delay

countdown will terminate the exit delay countdown and arm the system.

87. EXIT – FINAL – similarly as the 6. EXIT, but the zone restore during exit delay countdown

will terminate the exit delay countdown and arm the system.

88. 24H BURGLARY – a permanently armed zone. Its violation will cause the burglary alarm.

89. FINISHING EXIT DELAY – zone violation will reduce the partition exit delay time. It is possible

to program a shorter exit delay time. If this value remains not programmed, the exit delay

will be reduced to 4 seconds from the zone violation. There will be no effect if the zone is

violated and the just running exit delay is shorter than that programmed for the zone.

90. DISABLING VERIFICATION – zone violation will disable verification of alarms in the partition.

All alarms will be unverified until next arming.

91. DETECTOR MASK – the permanently armed zone, dedicated to anti-masking control.

Violation of the zone will be treated by the control panel as detector trouble (masking).

92. OUTPUTS GROUP OFF – the zone allows to deactivate a selected group of outputs.

93. OUTPUTS GROUP ON – the zone allows to activate a selected group of outputs.

94. ENTRY/EXIT INTERIOR – similarly as the 0. ENTRY/EXIT, but it will only be armed in the case

of full armed status (arming modes 0 and 1).

95. ENTRY INTERIOR – similarly as the 1. ENTRY, but it will only be armed in the case of full

armed status (arming modes 0 and 1).

96. FIRE MONITORING – permanently armed zone. After the zone is violated, fire alarm

information is saved to the control panel memory.

97. FIRE PANEL FAULT. MONIT. – permanently armed zone. After the zone is violated, an event

is saved to the control panel memory.

4.3.6 Zone options

Power up delay – when the option is enabled, the zone will be bypassed for 120 sec. after

power-up (which prevents triggering alarms e.g. when starting the alarm control panel).

Priority – when this option is enabled, arming will be impossible, if the zone is violated (e.g.

windows have been left open, etc.).

Contr. by pulse(off-by state) – option for 82. ARM/DISARM zone type. If it is enabled,

violation of the zone will arm/disarm the partition (depending on the current status of the

partition). If the option is disabled, zone violation will arm, and the zone restore will disarm

the partition.

CHIME in module – with this option enabled, zone violation can be signaled in partition

keypads, code locks and readers expanders assigned to the same partition as the zone

(the option CHIME must be enabled in the expander).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Integra 64 Seite 58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Integra 64

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info