Bedienungsanleitung Satel Versa IP (Seite 66 von 93) (Englisch)

629722

Zoom out

Zoom in

Vorherige Seite

1/93

Nächste Seite

64 VERSA IP SATEL

Tamper signaling is blocked:

 when the control panel is running in service mode,

 when the ABAX system is running in test mode (ASP-105 and ASP-205),

 for 10 minutes after connecting the battery (ASP-100),

 for 40 seconds after power-on (ASP-105) / installing the battery (ASP-205).

It enables installation work to be carried out. Opening the tamper switch will not trigger

loud signaling, but information on tamper will be sent (when in service mode, the

control panel will not signal the tamper alarms). The command to block/unblock the

signaling connected with starting / ending the test mode or the service mode is sent

during the response time.

Wireless expanders of hardwired zones and outputs

The wireless expander of hardwired zones and outputs (ACX-200 or ACX-201) takes up 4

zones and 4 outputs in the system. The alarm system zone / output to which the zone /

output in ACX-200 or ACX-201 expander is assigned is programmed in the same way as the

other hardwired zones / outputs of the control panel. You should remember however that

sensitivity of the expander zones may be different from that programmed in the control panel:

– from 20 ms to 140 ms – the same as the value programmed in the control panel,

– above 140 ms – only some values are available: 300 ms, 500 ms, 700 ms, etc. every

200 ms (the programmed value is rounded up to that supported by the expander).

The EN50131-3 standard requires that zones must react to signals lasting more than

400 ms. It means in case of the wireless expanders of hardwired zones and outputs

that no values exceeding 300 ms should be entered when programming the sensitivity

(the higher the value, the lower the sensitivity).

The expander informs you about the zone status as it changes. Also the expander outputs

are controlled in real time. Only the programming of zones takes place during the response

time (in one period, data relating to configuration of one zone are sent to the expander

module, i.e. sending the information on settings of four zones require four response periods).

If communication with the controller is lost, all previously activated outputs will be

deactivated after 20 response periods.

Additionally, the ACX-201 expander module sends information about:

 status of AUX1 and AUX2 power supply outputs – information on overload is sent when

the AUX1 or AUX2 output load exceeds 0.5 A.

 battery status – information on low battery is sent when the battery voltage drops below

11 V for more than 12 minutes (3 battery tests). The expander will kept sending this

information to the controller until the battery voltage rises and remains above 11 V for

longer than 12 minutes (3 battery tests).

 AC power status – information on the loss of power supply is sent when the AC power loss

lasts for more than 30 seconds. The AC power restore is reported with the same delay.

Low battery information for the first zone of ACX-201 expander indicates overload of the

AUX1 or AUX2 power supply output, for the second zone – discharged battery, for the third

zone – loss of AC power.

230 V AC wireless controllers

Activation of the output to which the controller is assigned will result in energizing the

230 V AC electrical circuit (if reverse polarity of the output has been programmed, the circuit

will be deenergized).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Versa IP Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Versa IP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info