Bedienungsanleitung Scheppach BAP350 (Seite 23 von 80) (Deutsch, Englisch, Französisch, Finnisch)

781996

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

GB | 23

• 

cable.

• Use only extension cables that are pro-

tected from spray water and designed

for outdoor use. Always fully unroll a

cable drum before use. Check the ca-

ble for damage.

• Before any work on the equipment, dur-

ing work breaks and in the case of non-

use, remove the plug from the socket.

• The cross-section of mains connec-

tion lines must be no smaller than rub-

ber hose lines with the designation

H07RN-F. The line must be 10 m long.

The strand cross-section of the exten-

sion cable must be at least 1.5 mm2.

Inside the pump, lubricants are used

which may contaminate the liquids being

discharged in case of any improper oper-

ation or damage of the device.

6. Technical data

Dimensions L x

B x H

180 x 165 x 230

Mains connection 230V~ / 50 Hz

Power rating 350 W

Max. delivery rate 4000 l/h

Max. delivery

head 11 m

Max. water

temperature 35°

Protection type IPX8

Particle size max. 1 - 3 mm

Weight 3,8 kg

Subject to technical changes!

Electrical safety:

• After erection, the mains plug must be

freely accessible when the equipment

is in operation.

• Before operating your new pump, have

a specialist check:

• The earthing, the protective multi-

ple earthing; the residual current cir-

cuit breaking must be compliant with

the safety regulations of the energy

supply company and function with-

out fault,

• The protection of the electrical plug

connections from the wet.

•         

plug connections in an area that is



• Ensure that the mains voltage matches



• The electrical installation shall be ac-

cording to national wiring rules.

• Connect the equipment only to a sock-

et with a residual current protection de-

vice (residual current circuit breaker)

with a rated current of not more than 30

mA; minimum fuse 6 amperes.

• Before each use, check the equipment,

cable and plug for damage. Defective

cables are not to be repaired, but rather

replaced by new ones. Have any dam-

age to your equipment repaired by a

specialist.

• If the power cable for this equipment

is damaged, it must be replaced by

the manufacturer, a customer service

agent of the same or a similarly quali-



• Do not pull the plug from the socket by

the cable. Protect the cable from heat,

oil and sharp edges.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach BAP350 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info