www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
44 | GB
Measured sound pressure level LpA 99,6 dB(A)
Uncertainty KpA 3 dB
Guaranteed sound power level LwA 114 dB(A)
Measured sound power level LwA 110,3 dB(A)
Uncertainty KwA 3 dB
Vibration Front handle 6,72 m/s²
Vibration Rear handle 6,38 m/s²
Uncertainty 1.5 m/s²
7. Before starting up
m CAUTION!: Start the engine only when the saw is
fully assembled.
m CAUTION!: When handling the chain always wear
protective gloves.
Assembling the bar, and the chain
(Fig.3-6)
Open the box and assemble the bar and chain as fol-
lows:
1. Press the front hand guard back (Fig.14/Pos.3a)
so that the chain brake is disabled.
2. Loosen the two nuts (B) and remove the cover
(17) and spacer (A).
3. Mounting the stopper claw (Fig.3)
Insert the stopper claw (19) into the recesses of
the housing (see Fig. 3) and secure with the 2 x-
ing screws (19a). Use the tool supplied with the
assembly tools (10).
4. Slide the chain around the sprocket, next slide
the saw chain around the bar. Pay attention to the
installation direction of the chain. (Fig.4-5)
5. Insert the chain tensioning screw (Z) into the low-
er hole of the chain bar (Y). (Fig.4)
6. Install the cover (17) and tighten the nuts (B) by
hand.
Installation direction of the chain (shown Fig.5)
Tensioning the chain (Fig.6-8)
1. Hold the front part tight with your hand.
2. Adjust the chain tension using the tension screw
(C) so that the chain rests entirely on the bar, but
not under great tension.
3. Tighten the mounting nut (B) for the bar with the
key (12-15 Nm).
4. Check with your hand that the chain runs smooth-
ly on the rail and has the proper voltage.
5. Where necessary, set up the chain tension.
6. Technical data
Machine without guide
bar L x W x H 375 x 182 x 190 mm
Weight without guide
bar and saw chain and
empty tank
5.5 kg
Weight with guide bar
and saw chain and emp-
ty tank
7.0 kg
Cutting Length 47 cm
Guide bar length 51 cm
Automatic chain oiling ja
Saw chain Oil Special
Saw chain oil
Saw chain oil tank
capacity 260 cm3
Saw chain division 8,255 mm (0.325″)
Drive link thickness 1.5 mm (0,058”)
Saw chain type Oregon 21BPX078X
Number of teeths drive
sprocket 7
Tooth pitch of drive
sprocket 8,255 mm (0.325″)
Chain brake yes
Guide bar type Oregon 208PXBK095
Saw chain speed max. 22 m/s
Motor 1 cylinder 2 stroke
air cooled
Engine capacity 56 cm³
Maximum motor capacity 2,3 kW
Idle speed 3300±200 rpm
Maximum speed with
cutting attachment 11000 rpm
Fuel tank capacity 550 cm3
Fuel type mix 40:1
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect working
order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance o when it is not in use.
• Wear protective gloves.
