781866
32
Zoom out
Zoom in
Vorherige Seite
1/148
Nächste Seite
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58 www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
32 | GB
16. Trouble shooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Engine fails to start.
Spark plug wire disconnected. Attach spark plug wire securely to spark plug.
Out of fuel or stale fuel. Fill with clean, fresh gasoline.
Throttle control lever not in correct
starting position. Move throttle control lever to start position.
Choke not in ON Position. Throttle must be positioned at choke for a cold
start.
Blocked fuel line. Clean the fuel line.
Fouled spark plug. Clean, adjust gap, or replace.
Engine ooding. Wait a few minutes to restart, but do not prime.
Engine runs erratically.
Spark plug wire loose. Connect and tighten spark plug wire.
Unit running on CHOKE. Move choke lever to OFF.
Blocked fuel line or stale fuel. Clean fuel line. Fill tank with clean, fresh gas-
oline.
Vent plugged. Clear vent.
Water or dirt in fuel system. Drain fuel tank. Rell with fresh fuel.
Dirty air cleaner. Clean or replace air cleaner.
Engine overheats. Dirty air cleaner. Clean air cleaner.
Air ow restricted. Remove housing and clean.
Engine will not stop when
throttle control is positioned
at stop, or engine speed does
not increase properly when
throttle control is adjusted.
Debris interfering with throttle link-
age. Clean dirt and debris.
Pull cord damaged Contact specialist dealer
Compactor is difcult to con-
trol when pounding (machine
jumps or lurches forward)
Too high engine speed on hard
ground.
Set the throttle lever at lower speed.
Shock absorber too loose or dam-
aged. Contact specialist dealer
No compacting function or
the plate compactor does not
reach the maximum speed
Damage on exciter or plate compac-
tor. Contact specialist dealer
Drive belt too loose and slips on the
pulley. Adjust or replace the drive belt
Oil loss from engine or exciter Worn seal. Contact specialist dealer
Leaks on housing.
IM_5904612903_HP2200s_191212_new.indd 32IM_5904612903_HP2200s_191212_new.indd 32 12.12.2019 07:40:2112.12.2019 07:40:21
32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Scheppach HP2200S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info