Bedienungsanleitung Scheppach LB2600E (Seite 17 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

781389

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

17 І 64

1. Damage to hearing if no suitable ear protection is used.

2.Health damage caused by hand-arm vibrations if the

equipment is used over a prolonged period or is not

properly guided and maintained.

3.Remaining hazards can be minimized by following the

instructions in Safety Precautions, Proper Use and in

the entire operating manual.

Warning! This electric tool generates an electromag-

netic eld during operation. This eld can impair active

or passive medical implants under certain conditions. In

order to prevent the risk of serious or deadly injuries, we

recommend that persons with medical implants consult

with their physician and the manufacturer of the medical

implant prior to operating the electric tool.

6. Technical data

Rated input voltage 230-240 V ~ 50 Hz

Input power 3000 W

Protection class II

Safety class IPX20

Air capacity 11-13.5 m3/min

Air speed 275 km/h

Shredding rate 10:1

Content of the collection

bag 45l

Sound pressure level (LpA)86,3 dB(A)

Uncertainy KpA 3 dB(A)

Sound power level measured

(LwA)104 dB(A)

Sound power level guaran-

teed (LwA)100,3 dB(A)

Uncertainy KwA 3,57 dB(A)

Vibration at the handle (ah)2,765 m/s2

Vibration additional grip (ah)2.765 m/s2

Uncertainy K 1.5 m/s2

Noise and vibration

Total vibration values determined in accordance with EN

61029.

Wear hearing protection!The effects of noise can

cause a loss of hearing. Total vibration values (vector

sum - three directions) determined in accordance with

EN 61029.

7. Before starting the equipment

Before you connect the equipment to the mains supply

make sure that the data on the rating plate are identical

to the mains data.

Warning!

Always pull the power plug before making adjust-

ments to the equipment.

Start up the equipment only when fully assembled.

Always inspect the power cable for damage before star-

ting up. The equipment may be used only if the cable is

in awless condition.

• Handle the unit with care. Clean the ventilation slits

regularly; keep to the maintenance instructions.

• Do not overload your device. Work only within

the indicated range of performance. Do not em-

ploy any low power machines for heavy work.

Do not use your device for purposes for which it has

not been designed.

• Do not attempt to repair the appliance yourself unless

you have specic training to do so. Leave any work not

listed in this manual to our Service Centre.

• Check the grass bag regularly for wear or damage.

Electrical safety:

CAUTION! The following states how to avoid accidents

and injuries due to electric shock:

• Make sure that the mains voltage is compatible with

the information of the label.

• Connect the device, as far as possible, only to a plug

socket with a groundfault circuit interrupter (g.f.c.i switch),

with a rated residual current at not more than 30 mA.

• Check the device and the power cable with plug for

damage before every use. Avoid bodily contact with

grounded parts (e.g. metal fences, metal post).

• The coupling of the extension cord must be protected

against splashed water, it must consist of rubber or be

surrounded by rubber. Employ only extension cords

which are stipulated for use in the open air and are

marked accordingly. The exible lead crosssection

of the extension cord must at least 1.5 mm2. Always

roll out the cable drum completely before use. Check

the cable for damage.

• Keep the cable away from the eld of action and basi-

cally play it out behind the operator.

• Use the tension relief provided for the xing of the

extension cord.

• Do not carry the device by the cable. Do not use the

cable to pull out the plug from the plug socket. Protect

the cable against heat, oil and sharp edges.

• Damaged cables, coupling and plugs or connecting

leads not corresponding to specications, must not

be employed. Remove the plug immediately from the

plug socket in case of damage to the mains cable.

Do not touch the mains power supply cable under

any circumstances until you have pulled the plug out

of the mains socket.

• If the power cable for this equipment is damaged, it

must be replaced by the manufacturer, a customer

service agent of the same or a similarly qualied per-

son in order to prevent hazards.

• Do not use the appliance if the on/off switch does

not work properly. Always have a damaged switch

repaired by our Service Centre.

• Before each use, check the power supply lead and

the extension cable for damage and ageing. Do not

use the equipment if the cable is damaged or worn.

Residual risks

Even if you use this electric power tool in accordance

with instructions, certain residual risks cannot be

rules out. The following hazards may arise in connec-

tion with the equipment’s construction and layout:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach LB2600E Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info