Bedienungsanleitung Scheppach SC40P (Seite 19 von 71) (Deutsch, Englisch, Holländisch, Französisch)

781423

Zoom out

Zoom in

Vorherige Seite

1/71

Nächste Seite

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

GB | 19

5. Do not put hands or feet near rotating parts

6. Avoid contact with hot fuel, oil, exhaust fumes and

hot surfaces. Do not touch the engine or mufer.

These parts get extremely hot from operation.

They remain hot for a short time after you turn

off the unit. Allow the engine to cool before doing

maintenance or making adjustments.

7. If the machine should start to make an unusual

noise or vibration, immediately shut off the en-

gine, disconnect the spark plug wire, and check

for the cause. Unusual noise or vibration is gener-

ally warning of trouble.

8. Use only attachments and accessories approved

by the manufacturer. Failure to do so can result in

personal injury.

9. Maintain the machine. Check for misalignment or

binding of moving parts, breakage of parts and

any other condition that may affect the machine’s

operation. If damaged, have the machine repaired

before use. Many accidents are caused by poorly

maintained equipment.

10. Keep the engine and mufer free of grass, leaves,

excessive grease or carbon build up to reduce the

chance of a re hazard.

11. Keep cutting tools sharp and clean. Properly

maintained cutting tools with sharp cutting edges

are less likely to bind and are easier to control.

12. Never douse or squirt the unit with water or any

other liquid. Keep handles dry, clean and free

from debris. Clean after each use.

13. Observe proper disposal laws and regulations for

gas, oil, etc. to protect the environment.

14. Store idle machine out of the reach of children

and do not allow persons unfamiliar with the ma-

chine or these instructions to operate it. Machine

is dangerous in the hands of untrained users.

Instructions for maintenance

Before cleaning, repair, inspecting, or adjusting, shut

off the engine and make certain all moving parts have

stopped. Disconnect the spark plug wire, and keep

the wire away from the plug to prevent accidental

starting. Have your machine serviced by qualied

repair personnel using only identical replacement

parts. This will ensure that the safety of the machine

maintained.

Fuel Safety

1. Fuel is highly ammable, and its vapors can ex-

plode if ignited. Take precautions when using to

reduce the chance of serious personal injury.

2. When relling or draining the fuel tank, use an

approved fuel storage container while in a clean,

well-ventilated outdoor. Do not smoke, or allow

sparks, open ames or other sources of ignition

near the area while adding fuel or operating the

unit. Never ll fuel tank indoors.

3. Keep grounded conductive objects, such as tools,

away from exposed, live electrical parts and con-

nections to avoid sparking or arcing. These events

could ignite fumes or vapors.

4. Always stop the engine and allow it to cool before

lling the fuel tank. Never remove the cap of the

fuel tank or add fuel while the engine is running

or when the engine is hot. Do not operate the ma-

chine with known leaks in the fuel system.

5. Loose the fuel tank cap slowly to relieve any pres-

sure in the tank.

6. Never over ll fuel tank. Fill tank to no more than

12.5 mm (1/2” below the bottom of the ller neck

to provide space for expansion as the heat of the

engine can cause fuel to expand).

7. Replace all fuel tank and container caps securely

and wipe up spilled fuel. Never operate the unit

without the fuel cap securely in place.

8. Avoid creating a source of ignition for spilled fuel.

If fuel is spilled, do not attempt to start the engine

but move the machine away from the area of spill-

age and avoid creating any source of ignition until

fuel vapors have dissipated.

9. Store fuel in containers specically designed and

approved for this purpose.

10. Store fuel in a cool, well-ventilated area, safely

away from sparks, open ames or other sources

of ignition.

11. Never store fuel or machine with fuel in the tank

inside a building where fumes may reach a spark,

open ame, or other sources of ignition, such as a

water heater, furnace, clothes dryer and the like.

Allow the engine to cool before storing in any en-

closure.

Instructions for use and maintenance of the ma-

chine

1. Never pick up or carry a machine while the engine

is running.

2. Do not force the machine. Use the correct ma-

chine for your application. The correct machine

will do the job better and safer at the rate for which

it was designed.

3. Do not change the engine governor settings GB

or over-speed the engine. The governor controls

the maximum safe operating speed of the engine.

4. Do not run the engine at a high speed when you

are not tilling.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach SC40P Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Scheppach SC40P

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info