Bedienungsanleitung Scholtes FP 955.1 (Seite 24 von 84) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

495430

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could

scratch the surface and cause the glass to crack. To

clean more thoroughly, you can remove the oven door.

• Open the door fully and lift up the two small levers

“B”;

• Now, when the door is closed slightly, it can be

lifted out by removing hooks “A” as shown in

figure.

To replace the door:

• With the door in an upright position, insert the 2

hooks “A” into the vents;

• Make sure that slot “D” is perfectly fastened to

the edge of the vent (move the door forwards and

backwards slightly);

• Keep the door completely open, shift the 2 levers

“B” downwards, then close the door.

Inspecting the seals

Check the door seals around the oven at regular

intervals. If the seals are damaged, please contact

your nearest Service Centre (see Assistance). We

recommend that the oven is not used until the seals

have been replaced.

Replacing the light bulb

To replace the

oven light bulb:

1. Remove the glass cover using a screwdriver.

2. Unscrew the light bulb and replace it with a

similar one: Wattage 15 W, cap E 14.

Replace the glass cover, making sure the seal is

positioned correctly (see diagram).

Assistance

Warning:

The appliance is fitted with an automatic diagnostic

system which detects any malfunctions.

Malfunctions are signalled through messages of the

following type: “F”, followed by numbers.

Call for technical assistance in the event of a

malfunction.

! Never use the services of an unauthorised

technician.

Please have the following information to hand:

• the type of problem encountered;

• the appliance model (Mod.);

• the serial number (S/N).

The latter two pieces of information can be found on

the data plate located on the appliance.

Glass door

Seal

Lamp

Oven

compartment

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scholtes FP 955.1 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info