277If and when
Changing the dipped beam headlight bulb
The procedure for changing the bulb is the same on both
sides.
Fig. 210 Dipped beam
headlights
Fig. 211 Dipped beam
headlights
–Switch off the ignition and the lights.
–Raise the bonnet.
–Move the brace ⇒ Fig. 210 1 in the direction of the arrow and
remove the rigid cover, separating the brace side and then re-
moving the two tabs from the other end of the cover.
–Pull the connector ⇒ Fig. 211 2 from the bulb.
–Unclip the retainer spring ⇒ Fig. 211 3 pressing inwards to the
right.
–Remove the bulb and fit the new one in the headlight casing
with the tab upwards, starting to position it from below.
–Clip on the spring, raising it and pressing it slightly while turn-
ing it anticlockwise. To ensure correct lighting, the filament
must be vertical. When changing the bulb, you can check the
position of the bulb through the headlight glass.
–Connect the connector to the bulb.
–Fit the cover, first inserting the side tabs and then closing the
cover and the brace. Make sure that the gasket sits well on the
casing cover during the operation.
–Check whether the new bulb is working.
–Have the headlight settings checked as soon as possible.
Safety First Operating Instructions Practical Tips Technical Specifications
