Bedienungsanleitung SEG HS 923 (Seite 15 von 16) (Deutsch, Englisch)

788844

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

• Keep the hair straightener in the charging station while

it is heating up. This way the heating plates remain pressed

together, preventing heat from escaping too quickly.

Otherwise, it will take a lot longer to reach the desired temperature.

• Each time that the appliance is switched on, the temperature setting

of 200 °C is always selected by default.

• To protect your hair, always start with the lowest temperature setting,

and increase the temperature only if needed. The lighter, thinner or more

sensitive the hair is, the lower the temperature should be to protect the hair.

This also applies for bleached or coloured hair. A higher temperature can

be selected for very thick, curly hair.

MTo switch the appliance to standby, press and hold the standby

button for approx. 3 seconds.

Straightening hair

WARNING – risk of ﬁre/burns

• The heating plates get very hot during use. Make sure that you keep

enough distance between the heating plates and your skin, ears and face.

Do not touch the heating plates. Only hold the appliance at the far end.

• Only hold the hair straightener in the same position on the hair for

a short amount of time. Do not go over the same section of hair several

times in a row. Otherwise, you may damage your hair.

As your hair comes into contact with extremely high temperatures

when you are straightening it, keep the following in mind:

• When choosing a shampoo or other hair care products, check that they

will moisturise your hair.

• Before straightening, use a product that will protect your hair

against heat. Suitable products are available from your hairdresser

or from a health and beauty retailer.

Charging the battery

Before using the appliance for the ﬁrst time, the battery must be fully

charged. The appliance cannot be switched on while charging.

DANGER – risk of fatal electric shock

Do not charge the appliance directly next to or over a washbasin ﬁlled with

water.

























USB

1. Connect the USB-C charging cable

to the charging station and a USB

mains adapter (not included).

2. Plug the mains adapter into

a wall socket.

3. Ensure that the appliance is

switched off (the On/Off switch

is set to OFF).

4. Press the heating plates at the top

of the hair straightener together.

5. Insert the hair straightener into

the charging station as illustrated,

making sure to push it all the way

down.

The charging process will begin automatically.

During charging, the hair straightener’s charging indicator light will light

up in ...

... orange if the battery‘s capacity is below 90 %.

... white if the battery‘s capacity is above 90 %.

When the battery has fully charged, the charging indicator light will go out.

117101 en Akku-Haarglaetter_v5.indd Druckbogen 7 von 8 - Seiten (10, 7)117101 en Akku-Haarglaetter_v5.indd Druckbogen 7 von 8 - Seiten (10, 7) 09.09.21 09:4709.09.21 09:47

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

SEG HS 923 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info