The hour now starts to flash on the LCD. Select the desired hour by using the ▲ or ▼ button.
Press the SET button to confirm your selection.
The minute now starts flashing on the LCD. Select the desired minute by using the ▲ or ▼
button. Press the SET button to confirm your selection.
The LCD display should now be steady, with nothing flashing. This allows you to verify that
the correct day/s, hour/s and minute/s has been entered.
Press the ▲ button to program the switch OFF time. “1OFF” will be shown on the lower left
corner of the LCD. This indicates that Program Block 1 out of a possible 20 is now selected
and the switch OFF time can now be set.
Repeat the above steps to set the switch OFF time.
Press the ▲ button to select the next program block OR press the CLOCK button to finish
programming OR refrain from pressing any mote buttons and the timer will automatically
revert back to Clock mode.
Setting the timer countdown function
This feature allows you to set a time for a delayed switch ON or switch OFF.
With the Timer in Clock mode press the ▼ button. The Bottom left hand corner on the LCD
will show “d ON (or OFF)” indicating the timer is now in countdown mode.
Press the SET button until the ON or OFF display flashes. Pressing the ▲ or ▼ buttons
changes the status from ON to OFF and visa versa.
Pressing the SET button again confirms the selection and allows you to set the Hour, if so
desired, or press the SET button again to se the Minute/s and again if you want to set the
seconds.
NOTE: Pressing the SET button will allow you to navigate through the sequence of:
Status (ON/OFF)→Hour(s)→Minute(s)→Second(s)
You need only to set or change the components that you want.
For example: If you wish a table lamp to remain ON for 10 minutes after you leave the house,
set the Status to ON and if the time on the LCD is all zeros you can proceed straight to the
Minute and set that to 10.
After setting the required Delay period press the CLOCK button to return the Timer to Clock
mode.
Activating the delay function
The delay function can only be activated when the Timer is in Clock mode and only when the
Timer is plugged into an outlet.
Ensure the Timer is in Clock mode.
