Bedienungsanleitung Severin HV 7186 (Seite 16 von 104) (Alle Sprachen)

794445

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

142 x 208 mm

Recommended suction mode:

ECO : for slightly soiled hard oors, curtains, drapes and the like

MIDDLE : for slightly soiled carpets, heavily soiled hard oors

POWER : for carpets, rugs, upholstery, mattresses and car seats

TURBO mode : for heavily soiled oor coverings or upholstery

Approximate running time in power modes

With a fully charged battery, the running time is as follows:

ECO : approx. 60 minutes

MIDDLE : approx. 30 minutes

POWER : approx. 12 minutes

TURBO mode : the appliance switches to POWER mode in 2 minutes

Maintaining the appliance

Dust level indicator

∙The appliance is equipped with a dust level indicator. Make sure you change the dust bag or empty the dust container

when the LED above the display on the handle lights up red.

∙The LED ashes when the dust bag needs to be changed promptly or the dust container needs to be emptied promptly.

∙When the LED glows red steadily, the appliance is rendered inoperable and requires prompt change of the dust bag or

emptying of the dust container.

For appliances without dust bags

Emptying the dust container

∙The dust container can only hold a limited quantity of dirt.

∙It is therefore highly recommended that you empty the dust container after every cleaning und when the suction power

drops noticeably or when the dust level indicator lights up red:

1. Make sure that the appliance is switched off.

2. Remove the tool and the suction tube.

3. Push the locking latch on the bottom of the dust container. Open the ap of the dust container and empty the dust

container.

4. Close the ap of the dust container.

Cleaning the dust container

∙You can easily clean the dust container with lter:

1. Make sure that the appliance is switched off.

2. Remove the tool and the suction tube.

3. Press the button on the top of the appliance and remove the dust container by pulling it downwards.

4. Push the locking latch on the bottom of the dust container. Open the ap of the dust container and empty the dust

container. (see Fig. III)

5. Fold the handle (semicircle) back on the dust container lter and remove the lter.

6. Loosen the lter insert with metal sieve by turning it and then remove it.

7. Pull out the foam lter and brush it off carefully if necessary.

8. All lter parts should be rinsed with lukewarm water and allowed to dry for 24 hours.

9. The dust container should be rinsed with lukewarm water and allowed to dry for 24 hours with the lid open.

10. We recommend that you dry the parts on a radiator. Make sure that the parts are completely dry before reassembling

them.

11. Replace the dry foam lter, attach the lter insert with metal sieve and turn to lock in place.

12. Slide the lter back into the dust container. The locking tab on the lter must t into the dust container recess.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin HV 7186 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info