Bedienungsanleitung Severin KA 5991 (Seite 15 von 88) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

544447

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

over the rim of the ﬁ lter sieve.

Removing the used espresso pad:

∙ After the brewing cycle is complete, wait

for approximately 30 seconds until the

operating pressure has been sufﬁ ciently

reduced.

∙ Exercise caution when removing

the ﬁ lter holder: it is hot and may still

contain some hot water. Pour out the

water carefully.

∙ Allow the ﬁ lter holder to cool down

sufﬁ ciently before tapping its side against

a vertical surface to loosen the pad

before removing it.

∙ The cut-out on the ﬁ lter holder makes

it easier to remove the ﬁ lter sieve; use

the ﬁ ngers to pull the sieve out from

above. Clean the ﬁ lter holder and sieve

thoroughly.

Drip tray

During operation, any excess water or steam

is collected in the drip tray. The tray must

therefore be ﬁ tted whenever the espresso

maker is switched on. Caution: the drainer

and tray become very hot during use.

Always empty the drip tray in good time to

prevent water spillage.

Do not remove the drip tray unless the

appliance has been switched off and has

had sufﬁ cient time to cool down.

Preparation

Espresso

∙ Fill the container with water.

∙ Insert the plug into a suitable wall outlet

and use the On/Off switch to turn the

appliance on. The main red indicator light

comes on.

∙ Preheat the ﬁ lter holder and the cup.

∙ Remove the ﬁ lter holder, ﬁ ll with ground

espresso coffee or load a pad and re-

attach it.

∙ Place the cup under the ﬁ lter holder

outlet.

∙ Wait until the green temperature indicator

shows a steady light and turn the rotary

control to position

∙ The pre-brewing function starts, ie the

ground espresso is pre-moistened with

water to ensure that the maximum coffee

ﬂ avour is released.

∙ The actual brewing process starts after

a short while, and the espresso is now

delivered straight into the cup.

∙ Once the cup is full, turn the rotary control

to its neutral position to switch the pump

off (position ).

∙ Wait for approximately 30 seconds before

detaching the ﬁ lter holder and removing

the espresso grounds.

∙ The espresso maker is now ready for

another brewing cycle.

Cleaning and care

∙ Before cleaning the espresso maker,

ensure it is disconnected from the power

supply and has cooled down completely.

∙ To avoid the risk of electric shock, do not

clean the appliance with water and do not

immerse it in water.

∙ Do not use abrasives or harsh cleaning

solutions.

∙ All removable parts may be cleaned with

warm, soapy water; these parts are not

dish-washer safe.

∙ Empty the drip tray daily and clean the tray

and drainer with warm, soapy water.

∙ The exterior housing may be wiped with a

dry or slightly damp, lint-free cloth.

∙ The boiler outlet may be wiped with a

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KA 5991 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info