Bedienungsanleitung Severin KA 9582 (Seite 13 von 84) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Finnisch)

761728

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

142 x 208 mm

Pre-heating cups

For optimum taste enjoyment we recommend to pre-heat

the cups. Rinse the cups with hot water or place them on

the cup-warming top.

Making espresso

∙ Remove the water container, open the lid and ll with

fresh water, observing the min/max marking.

∙ Ensure that the rotary control is set to .

Using espresso powder:

∙ Fit the lter insert for one or two cups into the lter

holder.

∙ Load the lter insert with the desired amount of espresso

coffee. We recommend 7.5 g per cup.

∙ Use the tamper to push down the espresso coffee

evenly and rmly with a pressure of around 15 kg.

∙Hint: After tampering, the compressed surface should

be about 2 mm down from the rim inside the lter

holder.

∙ Remove any excess coffee from the rim of the lter

holder.

Using ESE pods:

∙ Fit the lter insert for ESE pods into the lter holder.

∙ Insert a pod.

∙ Fit the lter holder with the handle facing left to

the boiler outlet. Secure the lter holder by turning the

handle to the right, locking it underneath the symbol.

∙ Place one or two cup(s) onto the drip tray underneath

the outlet opening.

∙ Press to turn the unit on. The cup symbols start

ashing slowly while the unit is pre-heating.

∙ Once the cup symbols are permanently lit, the brewing

process can be started by pressing or button.

∙ Once brewing is complete, remove the cup(s) and

switch the unit off.

∙ Allow the lter holder to cool down, then remove and

clean it as described in Cleaning and care.

∙ To avoid spilling, always empty the drip tray in good

time, observing the red oat indicator.

∙Hint: If the appliance has been used for frothing or

hot water, it must be allowed to cool down before

making espresso. The and buttons are

ashing rapidly to show that the unit is too hot.

To accelerate cooling, you can release water from

the panarello. Place a suitable container underneath

the panarello and set the rotary control to for

around 2 seconds. The unit is ready for use when the

and buttons are permanently lit.

Making cappuccino

∙ First prepare the espresso as described in Making

espresso.

∙ Fill a suitable heat-resistant jug with about 100 ml of

fresh, cold milk from the fridge.

∙ To prevent the milk from spilling over during the frothing

process, the jug should be only half full.

∙ Press . The button ashes while the unit is pre-

heating.

∙ Once the button shows a steady light, place the milk

jug underneath the panarello so that the lower of the

panarello is just submerged in the milk.

∙ Turn the rotary control to the position. The

panarello is now open.

∙ Turn the jug with a circular motion for around 40-45

seconds.

∙ Once the milk is sufciently frothy, turn the control back

to the espresso symbol ( ).

∙ Use a spoon to spread the milk froth over the espresso.

The proper ratio should be 1/3 espresso, 1/3 hot milk

and 1/3 milk froth.

Dispensing hot water

∙ Remove the water container, open the lid and ll with

fresh water, observing the min/max marking.

∙ Press to turn the unit on.

∙ Once the and buttons shows a steady light,

place a suitable container underneath the panarello.

∙ Set the rotary control to .

∙ Once hot water has been drawn, set the rotary control

back to .

Change factory settings

∙ The unit has various functions which may be modied as

follows:

∙ Turn the unit on and wait until the cup symbols are

permanently lit.

∙ Press the button for 10 seconds to enter the Change

factory settings mode. All three buttons ash alternately.

∙ Modify the default factory settings as described further

below.

∙ If no input is registered for about 15 seconds, the unit

returns to ‘Ready’ mode.

∙ To return the various functions (water hardness,

automatic switch-off, temperature, amount) back

to their factory settings, press the buttons and

simultaneously, keeping them pressed for three

seconds. The , and buttons start ashing

and two beep signals are heard. The appliance switches

off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KA 9582 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info