Bedienungsanleitung Severin KS 9838 (Seite 11 von 84) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

712715

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Familiarisation

1. Ice cube maker

2. Temperature control

3. Drip tray

4. Removable storage rack

5. Cold storage compartment

6. General storage

7. Bottle storage

8. Adjustable foot

The upper section of the unit contains a cold-storage

compartment that can be closed by a door.

Before using for the ﬁ rst time

∙ Remove any exterior and interior packaging materials

completely, including the adhesive strips.

∙ Please ensure proper disposal of all packaging materials.

∙ Before it is connected to the mains, the unit must be

thoroughly checked for transport damage, including its

power cord.

∙ Clean the unit as described in the section De-frosting and

cleaning.

∙ The unit should only be transported in its vertical position;

do not tilt any more than 30°.

∙ Once the unit has been positioned, wait for about 30

minutes before it is connected to the mains.

∙ If the unit has been tilted more than 30° during transport,

allow it to stand upright for at least 4 hours before it is

connected to the mains.

∙ When the unit is ﬁ rst switched on, a slight ‘new’ smell

may be noticed. However, this will disappear once the

cooling process has begun.

Installation

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ It should be operated in conditions where the relative

humidity is no more than 70 %.

∙ The product data sheet at the end of this manual contains

details of the ambient temperature range suitable for this

appliance.

∙ Do not use the appliance outdoors.

∙ Ensure that the plug is accessible and can be removed

from the wall socket at any time.

∙ Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers

etc). If this cannot be avoided, however, a suitable

insulation must be in installed between the heat source

and the unit.

∙ The unit must not be installed inside a cabinet, nor

directly below a hanging cupboard, shelf or similar object.

∙ Do not place any objects on top of the unit, and do not

otherwise cover it.

∙ If the ﬂ oor is uneven, the height-adjustable feet at the

front of the unit can be used to compensate and ensure

optimum stability.

Ventilation

Ensure that there is enough space around the unit so that

the air circulation round and behind it is not obstructed.

(Rear 7.5 cm, sides 5 cm, top 10 cm.)

Reversible door

If required, the door may be reversed, i.e. from right-hinged

(default installation) to left-hinged.

Warning: Always disconnect the unit from the mains before

any maintenance or repair work is carried out.

1. Remove the hinge cover (1).

2. Use a suitable pointed tool to remove the cover (5).

3. Use a suitable screw-driver to remove the two screws

(2) holding the upper hinge (3) to the housing.

4. Carefully lift up the door and place it on a soft surface

to protect it from scratches.

5. Remove the blind covers for the hinge mounting holes

(9) and ﬁ t it in the corresponding place on the right.

Ensure that the cover is ﬁ rmly pushed down into the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9838 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info