Bedienungsanleitung Severin KS 9838 (Seite 13 von 84) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Finnisch)

712715

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Transporting the appliance

To prevent damage to the unit during transport, ensure that

all accessories and components inside and around the

appliance are securely fastened.

The unit must only be transported in its vertical position; do

not tilt any more than 30°.

Once the unit has been positioned, wait for about 30

minutes before it is connected to the mains.

If the unit has been tilted more than 30° during transport,

allow it to stand in an upright position for at least 4 hours

before it is connected to the mains.

Disposal

Devices marked with this symbol must be

disposed of separately from your household

waste, as they contain valuable materials which

can be recycled. Proper disposal protects the

environment and human health. Your local authority or

retailer can provide information on the matter. The

refrigerant and the chemical agent in the insulation foam

must be disposed of through a competent agency. Take

special care not to damage the cooling circuit before the unit

is handed over for competent disposal.

Guarantee

This product is guaranteed against defects in materials

and workmanship for a period of two years from the date

of purchase. Under this guarantee the manufacturer

undertakes to repair or replace any parts found to be

defective, providing the product is returned to one of our

authorised service centres. This guarantee is only valid

if the appliance has been used in accordance with the

instructions, and provided that it has not been modiﬁ ed,

repaired or interfered with by any unauthorised person, or

damaged through misuse.

This guarantee naturally does not cover wear and tear, nor

breakables such as glass and ceramic items, bulbs etc.

This guarantee does not affect your statutory rights, nor any

legal rights you may have as a consumer under applicable

national legislation governing the purchase of goods. If the

product fails to operate and needs to be returned, pack it

carefully, enclosing your name and address and the reason

for return. If within the guarantee period, please also provide

the guarantee card and proof of purchase.

Energy saving tips

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ Do not expose the appliance to direct sunlight, and

do not position it next to any heat sources (radiators,

cookers etc). If this cannot be avoided, however, suitable

insulation must be installed between the heat source and

the unit.

∙ Do not cover the ventilation openings and grilles, and

ensure sufﬁ cient air circulation behind the unit.

∙ The compressor (at the rear) should be cleaned at

regular intervals. Accumulated dust causes an increase in

energy consumption.

∙ Warm food should be allowed to cool down before it is

stored inside.

∙ Do not leave the fridge door open for too long when

loading or taking out food.

∙ Do not set a lower-than-necessary temperature. For

detailed information on the temperature settings, please

refer to the section Temperature control.

Trouble-shooting

Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by the

electrical motor within

the compressor

assembly; during

compressor start-up

the sound level will

be slightly higher for

a limited period of

time.

∙ caused by the cooling agent ﬂ owing through the circuit.

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

problems, check ﬁ rst whether a solution can be found using

this table. If the problem persists, disconnect the appliance

from the mains power and contact our Customer Service

Department.

Problem Possible cause and solution

The appliance is not

working at all.

∙ There is a power failure.

∙ The main fuse has blown.

∙ The temperature control is set to ‘0‘.

∙ The fuse in the wall socket (if applicable) has blown. This can be checked by connecting another

electrical device to the socket and checking for function.

The normal operating

sound changes or

becomes louder.

∙ Check for proper positioning (uneven ﬂ oor?).

∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing them to vibrate?)

∙ Are there any objects on top of the unit which might be vibrating?

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Severin KS 9838 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info