Bedienungsanleitung Sharp EL-2901PIII (Seite 4 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

480456

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

PAPER FEED KEY

LAST DIGIT CORRECTION KEY

NON-ADD / SUBTOTAL KEY:

Non-add – When this key is pressed right after an entry of a number in

the Print mode, the entry is printed on the left-hand side with the symbol

“#”. This key is used to print out numbers not subjects to calculation

such as code, date, etc.

Subtotal – Used to get subtotal(s) of additions and/or subtractions.

When pressed following the or key, the subtotal is printed with

the symbol “

◊

” and the calculation may be continued.

By pressing this key even in the Non-print mode, the displayed

number is printed without any symbol.

• When the POWER SWITCH; PRINT / ITEM COUNT MODE

SELECTOR is set “•”, “P” or “P•IC” position, and Date or Clock is

displayed, press this key to print the displayed contents, including “#”

symbol, from the left side of the paper roll.

Example:

Date printing

#15 • 09 • 2005 • • • • • •

(when the date is 15 September, 2005)

Clock printing

#10 • 30 • • • • • • • • • • •

(when the time is 10:30 a.m.)

#18 • 25 • • • • • • • • • • •

(when the time is 6:25 p.m.)

• When the Date / Clock printing is complete, the Calculation mode is

restored.

CLEAR / CLEAR ENTRY KEY:

Press this key twice, followed by , to print the set tax rate.

TOTAL KEY

EQUAL KEY

CHANGE SIGN KEY:

Changes the algebraic sign of a number (i.e., positive to negative or

negative to positive).

RECALL AND CLEAR MEMORY KEY

RECALL MEMORY KEY

TAX-INCLUDING KEY

PRE-TAX KEY

AVERAGE KEY:

Used to calculate the average.

GRAND TOTAL KEY

COST PRICE ENTRY KEY:

Press this key to enter the cost price.

SELLING PRICE ENTRY KEY:

Press this key to enter the selling price.

MARGIN ENTRY KEY:

Press this key to enter the margin.

DISPLAY SYMBOLS:

M:Appears when a number is in the memory.

–:Appears when a number is negative.

• : Appears when a number is in the grand total memory.

E:Appears when an overflow or other error is detected.

INK ROLLER REPLACEMENT

If printing is blurry even when the ink roller is in the proper position, replace

the roller.

Ink roller: Type EA-772R

WARNING

APPLYING INK TO WORN INK ROLLER OR USE OF UNAPPROVED INK

ROLLER MAY CAUSE SERIOUS DAMAGE TO PRINTER.

1) Set the power switch to OFF.

2) Remove the printer cover. (Fig. 1)

3) Hold the top of the ink roller and remove the roller by pulling it toward you and

then upward. (Fig. 2)

Fig. 1 Fig. 2 Fig. 3

PAPER ROLL REPLACEMENT

Never insert paper roll if torn. Doing so will cause paper to jam.

Always cut leading edge with scissors first.

1) Insert the leading edge of the paper roll into the opening. (Fig. 1)

2) Turn the power on and feed the paper by pressing . (Fig. 2)

3) Lift the attached metal paper holder up and insert the paper roll to the paper

holder. (Fig. 3)

Fig. 1

Fig. 3Fig. 2

4) Install the new ink roller in the correct position. Make sure that the roller is

securely in place. (Fig. 3)

5) Put back the printer cover.

Cleaning the printing mechanism

If the print becomes dull after long time usage, clean the printing wheel

according to the following procedures:

1) Remove the printer cover and the ink roller.

2) Install the paper roll and feed it until it comes out of the front of the printing

mechanism.

3) Put a small brush (like a tooth brush) lightly to the printing wheel and clean it

by pressing .

4) Put back the ink roller and the printer cover.

Note: • Do not rotate the printing mechanism manually, this may damage the

printer.

DO NOT PULL PAPER BACKWARDS AS THIS MAY CAUSE DAMAGE

TO PRINTING MECHANISM.

ERRORS

There are several situations which will cause an overflow or an error condition.

When this occurs, “E” will be displayed. The contents of the memory at the

time of the error are retained.

If an “0⅐E” is displayed at the time of the error, “– – – – – – –” will be printed in

red and must be used to clear the calculator.

Also, in rare cases, printing may stop midway and the indication “E” appear on

the display. This is not a malfunction but is caused when the calculator is

exposed to strong electromagnetic noise or static electricity from an external

source. Should this occur, press the key and then repeat the calculation

from the beginning.

Error conditions:

1. When the integer portion of an answer exceeds 12 digits.

2. When the integer portion of the contents of the memory or grand total memory

exceeds 12 digits.

(Ex. 999999999999 1 )

3. When any number is divided by zero. (Ex. 5 0 )

EL-2901PIII(AXO)(Hu)-Eng 07.11.7, 8:16 PMPage 2 Adobe PageMaker 6.5J/PPC

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp EL-2901PIII Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info