679539
8
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
6
3. VOL+/VOL- Increase/decrease the
volume level.
4.
PREVIOUS – Press to return to the
previous track.
5.
Press to temporarily pause a
playback. Press it again to resume the
playback. Hold down this button for
3 seconds to disconnect bluetooth.
6. EQUALIZER press repeatedly to
switch among Music/Movie/News
equalizer modes. Music mode -
indicator light will  ash once, Movie
mode - indicator light will  ash twice,
News mode - indicator light will  ash
three times.
7. MUTE Press to temporarily switch
o the sound. Press it again to switch
it on.
8. BT Press to enter to Bluetooth
mode. (Bluetooth mode - blue
indicator light)
9.
NEXT – Press to skip to the next
track.
10. OPTICAL/ARC Press to switch
between OPTICAL IN and HDMI
ARC mode.(OPTICAL mode - yellow
indicator light, HDMI ARC mode -
Cyan indicator)
RC OPERATIONS
Insert the battery into the remote control.
Point the remote control at the remote
sensor on the front panel. The remote
control works within a distance of about
8 metres from the sensor and within an
angle of about 30 degrees from the left
and right side.
BATTERY INSTALLATION
Remove the battery compartment co-
ver on the back of the remote control.
Insert one AAA/1.5V battery into the
battery compartment making sure that
the battery has been inserted with the
correct polarities matching the symbols
+, - as indicated inside the battery
compartment.
Place the battery compartment cover
back onto the Remote control
First time installation
Placement and Mounting
AB
A: Normal Placement
(Place Soundbar on leveled surface in
front of TV.)
B: Wall Mounting
Wall Mounting
NOTE:
Installation must be carried out by
quali ed personnel only. Incorrect
assembly can result in severe personal
injury and property damage (if you
intend to install this product yourself,
you must check for installations such
as electrical wiring and plumbing that
may be buried inside the wall). It is the
installer’s responsibility to verify that
the wall will safely support the total
load of the unit and wall brackets.
Additional tools (not included) are
required for the installation.
Do not overtighten screws.
Keep this instruction manual for future
reference.
Use an electronic stud  nder to check
the wall type before drilling and
mounting.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sharp HT-SB106 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info