Bedienungsanleitung Sharp LC-32GD7 (Seite 15 von 42) (Englisch)

66383

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Enter the appropriate channel number with the numeric buttons.

The corresponding bandwidth 7 or 8 MHz is set depending on the

channel and country.

Notes

You should only adapt the bandwidth if the channel spacing of the

stations in your area deviate from the standard.

If you receive a digital station, the signal quality (“C/N”) and the

signal strength level is displayed by a black bar/numeric value.

The antenna alignment or position is at an optimum when as high

a value as possible (large bar) is displayed for the signal quality

and signal strength.

The antenna should be aligned to give a maximum numeric

value/bar.

If no signal is found in the set channel, you can start the frequency

search within the selected band (VHF or UHF) by pressing the blue

button.

Check other channels on which digital stations are broadcast terrestri-

ally in your area one after another.

Align the antenna using the weakest station to as maximum as possib-

le a bar/numeric value.

Note: After the antenna has been positioned and aligned, we recommend

the “Automatic station programming” function to search for all stations

(see page 11).

New station search

This function is of particular advantage if you are only searching for new

stations.

Switch on your TV and if no menu is displayed, call the “TV menu” by

pressing the MENU button on the remote control

Select the ”Setup” item and conﬁ rm with OK.

Caution:

Only if you use an active terrestrial antenna, switch on the supply volt-

age (5 Volt). See page 9 under "Antenna".

Select “Channels” and conﬁ rm with OK.

Select “Search wizard” and conﬁ rm with OK.

You will get a table for the automatic station search.

If required select “Change search settings” and conﬁ rm with OK. Fol-

low the menus. Otherwise continue with step 10.

Select your “Location of TV set” and then indicate whether you are

searching via “Antenna/cable (analogue)”, “DVB-T” or in the “Satel-

lite 1: (DVB-S)” by marking the appropriate selection with the yellow

button.

•

In DVB-T you can select a channel search (fast station search) or a

frequency search.

Change search settings -> Signal source

Antenna/cable (analogue)

DVB-T

DVB-S

Indicate whether you wish to have “all” stations or “new ones only”

searched for.

Notes

The frequency search option is to be preferred only in exceptional

cases such as in the event of deviations from the standardized

channels.

If you have purchased a CI module, please insert it as described on

page 10.

Which of the stations of the provider you can watch in the end

depends on which station package you have bought.

To extend an existing station list we recommend you to activate

the option search and store “new ones only”.

For DVB-T stations in UK the stations are tied to “Logical Channel

Numbers” - „LCN“ and sorted from 1- 799. New digital stations

without “LCN” are stored from 800 onwards. Analogue stations

are stored behind the digital ones from 1001 onwards.

Conﬁ rm your selection with OK.

Select the “TV/Color standard” for “Signal source”: “Antenna/cable

(analogue)“ and conﬁ rm with OK.

Specify from which station place onwards the stations are to be

stored and conﬁ rm with OK.

Select “Start search” and conﬁ rm with OK.

The station search may take some time.

Do not make any entries or switch off the set during this time.

When the search has ended you will be shown the found and stored sta-

tions sorted in numerical order.

If you also want to search for and store analogue stations, repeat the

steps 5 to 10.

After the station search has been completed, close the table by pressing

the END button.

•

10.

11.

First installation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp LC-32GD7 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info