ENGLISH
42
Select the desired input source to enter its
label.
1
Press the LABEL button to enter the label
input mode.
Example ) When selecting VIDEO 1.
2
Select the character on the flickering digit.
3
Confirm your selection.
4
Repeat the above steps ③ and ④ to enter
the desired characters on the rest of the
digits.
5
Memorize the desired label.
6
Entering a label
Select the desired input source to be
rectified or cleared.
1
Repeat the steps ②~⑥ in “Entering a
label” procedure.
2
Correcting or clearing a label
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols: ( ) + , . – /
• You can select “VID 6” or “7.1 IN” on the page 2 of
“AUD 1” on the remote control.
• This function can be operated on the input sources
except TUNER and TAPE MONITOR.
• You can select “VID 6” or “7.1 IN” on the page 2
of “AUD 1” on the remote control.
• Then the next digit will flicker.
• On up to 9 digits, the desired characters can be entered.
Note: If any of INPUT SELECTOR buttons is
pressed while entering a label, the label input
mode will be canceled.
• To clear a label, make a blank on each digit and
memorize it, then the label is cleared and its factory
input source will be displayed.
• If the LABEL button is pressed for more than 3
seconds, blanks will be made on all the digits at
once.
