CONTENTS
3
ASSEMBLY
1. Please unpack set as confirm following parts.
• Turntable platter
• Slip Mat
• Dust Cover
• 45-rpm adaptor
• Counterweight
• Headshell
• Operating Instructions
2. Install the dust cover into Hinge pocket of the
upper cabinet.
3. Set the 45-rpm adapter on the main unit.
4. Set the turntable platter onto the [3] center spindle.
5. Attaching the Drive Belt
The belt has been properly positioned on the
motor pulley, remove the ribbon and place the
rubber mat and then set the slip mat on the [2]
platter.
6. Installation of cartridge:
When installing a cartridge, refer to the operating
instructions for that particular cartridge.
During installatiion, attach the stylus protector to
guard the stylus tip from damage.
a) Connect the lead wires to the cartridge terminals.
The terminals of most cartridges are color coded.
Connect each lead wire to the terinal of the same
color.
WHITE(L+) Left channel+
BLUE(L–) Left channel–
RED(R+) Right channel+
GREEN(R–) Right channel–
b) Install the cartridge to the [8] headshell and
tighten it with screws provided with the cartridge.
7. Insert the headshell into the front end of the [10]
tonearm, then turn the lock nut counterclockwise
with the [8] headshell firmly held horizontally.
8. Slide [16] counterweight onto [11] tonearm. Twist it
lightly and it will screw onto the rear shaft of the
tonearm.
9. Set the [14] anti-skating control knob to the same
value as the stylus.
