ENGLISH
18
USING FUNCTIONS OF REMOTE CONTROL
Entering a setup code
• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the
setup code for each component should be entered.
• For system remote control operation, “000” was stored previously in the memory of the device button “CD” for
Sherwood CD player, “DVD” for Sherwood DVD player, "AUX" for Sherwood tape deck and "TV" for Sherwood TV
respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except
in such a case that its code does not work.
• The LED will flicker once.
Note :
• The "AUD" button is unavailable for the audio
components other than this receiver.
• If entering is performed successfully, the LED will
flicker twice.
• To be sure that the setup code is correct, press the
POWER ON(or STANDBY) button.
If your component is tuned off, the setup code is
correct.
• When your component is not turned off, repeat the
above steps 2 to 4, trying each code for your
component until you find one that works.
Notes:
• If the LED did not flicker twice, then repeat the
above steps 3 to 4 and try entering the same
code again.
• Manufacturers may use different setup codes for
the same product category. For that reason, it is
important that you check to see if the code you
have entered operates as many controls as
possible. If only a few functions operate, check to
see if another code will work with more buttons.
1. Turn on the component you want to control.
2. Find the setup codes according to the type and
the brand name of your component, referring to
“Setup Code Table” on page 64.
3. Press and hold down both the "ENTER" button
and the desired one of the DEVICE buttons for
more than 1 second.
4. Enter a 3 digit code, aiming the remote control at
the remote sensor on the component.
5. Repeat the above steps 1 to 4 for each of your
components.
Example) When entering "001".
