563725
23
Zoom out
Zoom in
Vorherige Seite
1/126
Nächste Seite
19
en
Problem Cause Remedy
LED
D ashes.
The water tank is not
correctly installed or the
lter is worn.
Correctly install the water tank�
If the LED continues to ash,
install a new lter and rinse, see
chapter “Filter”�
Carbonated water in the
water tank�
Fill the water tank with fresh tap
water
The coffee grounds are
not compact and are too
wet�
The grind setting is too
ne or too coarse, or not
enough ground coffee has
been used�
Adjust the grinding unit to a
coarser or ner setting, or use
2 level measuring spoons of
ground coffee�
LED
I ashes.
Brewing unit (5) is soiled� Clean the brewing unit (5)�
Too much pre-ground
coffee in the
brewing unit (5)�
Clean the brewing unit (5) Put in
no more than 2 level measuring
spoons of ground coffee�
The brewing unit
mechanism is stiff�
Remove and clean the brewing
unit, see “Maintenance and daily
cleaning”�
Brewing unit (5) is missing
or has not been detected�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance again�
Coffee or milk froth quality
varies widely
Build-up of limescale in the
appliance�
Descale the appliance as
described in the instructions�
Water dripped onto the
inner oor of the appli-
ance when the drip tray
(8) was removed�
Drip tray (8) removed too
soon�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8)�
The default settings have
been changed and need
to be reset�
Some settings have been
made that are no longer
required�
Press the power on/off button O / I
(9) to switch off the appliance�
Press and hold the service button
(12) and the steam button (11)
and press the power on/off button
O / I (9) to switch on the appliance�
Then press the start button (10) to
conrm. The default settings are
reset�
LEDs
ash.
The appliance has a fault� Please contact the hotline�
LEDs
ash.
Incorrect voltage� Operate the appliance at
220 V-240 V only
LEDs
ash.
The ambient temperature is
too cold�
Operate the appliance at
temperatures > 5° C�
If you are unable to solve the problem, please call the hotline.
You will nd the telephone numbers at the back of these instructions.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Siemens TE501203 EQ 5 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info