Bedienungsanleitung Siemens TE501505 (Seite 10 von 117) (Englisch, Holländisch, Französisch, Italienisch)

508124

Zoom out

Zoom in

Vorherige Seite

1/117

Nächste Seite

4. Assemble the milk frother. Only use the

appliance when the milk frother (6) is

completely assembled and tted.

5. Lift the water tank lid (17).

6. Remove and rinse the water tank (16)

and ll it with fresh cold water. Do not ll

above the max mark.

7. Replace the water tank (16) and push it

rmly downwards into place.

8. Close the water tank lid (17).

9. Fill the bean container (1) with coffee

beans (for preparation using ground

coffee see “Preparation using ground

coffee” on page 13).

10. Press the power on/off switch O / I (9) to

switch on the appliance. LED D ashes

and LED F lights up.

11. Place a container under the milk frother

outlet (6).

12. Carefully pull out the milk frother (6)

to open it. The appliance rinses out

the milk frother (6) with water. LED F

ashes.

13. When LED F lights up constantly,

press in the milk frother (6) to close it.

The appliance heats up and rinses. Some

water will run out of the coffee outlet. When

buttons A (12), B (11) and C (10) light

up, the appliance is ready for use.

Switching off the appliance

If the appliance has not been used for

an hour, it rinses automatically and then

switches off (the length of time can be ad-

justed, see “Settings”, “Automatic switch-off”

on page 11).

Exception: The appliance switches off with-

out rinsing if only hot water or steam was

dispensed.

To switch the appliance off manually before

this, press the service button (12). The

appliance rinses and switches off.

Note: If the appliance is being used for the

rst time, the service programme has been

run, or the appliance has not been oper-

ated for a long period, the rst beverage will

not have the full aroma and should not be

consumed.

When the fully automatic espresso machine

is rst used, you will achieve a suitably thick

and stable “crema” only after the rst few

cups have been dispensed.

If the appliance is in use for a long period of

time, water droplets will form on the ventila-

tion slits. This is normal.

Water lter

Using a water lter can prevent a build-up

of limescale deposits.

A new water lter must be rinsed before it

can be used. To do this, proceed as follows:

1. Press the water lter rmly into the empty

water tank with the aid of the measuring

spoon (18).

2. Fill the water tank (16) with water up to

the max mark.

3. Turn the rotary

knob (13) to position

4. Press and hold buttons B (11) and A

(12) simultaneously for at least

5 seconds. Either “off” or “on”

lights up.

5. Press the start button (10) to select “on”.

6. Press and hold the start button (10) for

at least 5 seconds to conrm. All of the

LEDs light up briey.

7. LED D ashes and LED F lights up.

8. Place a container with a capacity of 0.5

litres under the milk frother outlet (6).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens TE501505 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens TE501505

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info