Bedienungsanleitung Siemens TJ10100 (Seite 30 von 131) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

473258

Zoom out

Zoom in

Vorherige Seite

1/131

Nächste Seite

Cleaning and maintenance

Be particularly careful when fitting the

ironing dummy and follow all the

instructions given.

The ironing dummy should only be fitted

when dry.

First fit the airbags:

❏ Each of the airbags (symmetrical) is joined

with a strip. This strip is fitted on the front

between the button band and the support

tubes. The airbag with an extra section with

2 snap fasteners in the middle must be fitted

on the left-hand side of the appliance

(looking head on).

❏ There are three snap fasteners on each side

of the shoulder area which are fitted to the

relevant airbag.

❏ Fit the adjustment cords onto the round

guides around the air-output grille and

secure the cord fixture. Fig. 21.

❏ Position the cross formation on the airbags

and close the snap fasteners on the front at

the bottom. Fig. 22.

The extra section on the bottom left-hand

side must be wrapped around the left-hand

tube, protecting the hole on the tube in this

area.

❏ Check that the adjustment cords are

secured properly.

❏ Check that the airbags are positioned

properly.

❏ Start the “ cold” programme. The

programme can be stopped at any time by

pressing the “start/stop” button.

❏ Check that the airbags are positioned

properly.

❏ Tighten any slack cords.

❏ Correct any problems.

❏ Fit the ironing dummy onto the upper part of

the appliance with the button band still

unlocked and the knob in its vertical

position.

❏ Fit the ironing dummy from back to front.

There are 4 holes on the front of the upper

part of the ironing dummy. The front

adjustment cords are on this section.

❏ When the dummy is fitted, set the knob to

horizontal.

❏ There are two guides on the head: front and

back.

❏ First fit the rear cord and then the front cord

into the guides on the collar and secure.

❏ The ironing dummy is joined to each airbag

via an interior cord. Fig. 23.

❏ Once the inner airbags have been fitted,

turn the sleeves of the ironing dummy

inside out.

❏ Then close the snap fasteners joining the

two parts and turn the sleeve (currently

inside out) outside out again. The arms of

the airbags are now inside the ironing

dummy arms. Fig. 24.

❏ Pull the ironing dummy downwards from the

underarms, Fig. 25. Fit the airbag arms into

the ironing dummy.

❏ Fit the lower adjustment cord on the ironing

dummy into the guide. Make sure that it is

secured properly. Fig. 26.

❏ On the front, the adjustment cord has to be

fitted under the 2 supports on the appliance

on the rear of the button band. Fig. 27.

❏ Tighten the fixture fitting for this cord.

❏ The fixture fitting has to be positioned into

the central rear groove, Fig. 26. Then pull

the adjustment cord again.

❏ Check that all of the adjustment cords are

secured properly.

❏ Close the button band. It clicks into position.

Check that the ironing dummy works properly:

❏ Start the “ cold” programme. The

programme can be stopped at any time by

pressing the “start/stop” button.

❏ Check that the ironing dummy is fitted

properly.

❏ Tighten any slack cords if necessary.

❏ Correct any problems.

❏ Fit the head section into the front guide.

Click the front hook into the hole on the top

part of the head.

❏ Press the head section until it clicks into

position. Fig. 28.

❏ Position each of the cuff adjusters and close

the relevant snap fasteners.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens TJ10100 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info