Bedienungsanleitung Siemens VS57E20 (Seite 16 von 119) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

73394

Zoom out

Zoom in

Vorherige Seite

1/119

Nächste Seite

Figure Opening the lid

Ⅲ

Press the control button down to the stop and leave

it retracted in the appliance.

Caution: Only open the lid with the control button

retracted.

Ⅲ

Open the lid by moving the locking lever in the

direction of the arrow.

Figure

a)Seal the dust bag by pulling the sealing strip and

remove the bag. .

b)Slide the new dust bag into the holder to the stop.

Caution: the lid will only close if a dust bag has been

inserted.

Cleaning the motor protection filter

The motor protection filter should be cleaned regularly

by knocking out the dirt or rinsing it out.

Figure

Ⅲ

Open the dust bag compartment lid

(see Figure 21).

Ⅲ

Pull out the motor protection filter in the direction of

the arrow.

Ⅲ

Clean the motor protection filter by tapping it.

Ⅲ

If it is very dirty, the motor protection filter should

be rinsed out.

The filter must then be left to dry for at least 24

hours.

Ⅲ

After cleaning, slide the motor protection filter into

the vacuum cleaner and close the dust bag

compartment lid.

Replacing the micro-hygiene filter

This should be replaced with every replacement filter

pack

Figure

Ⅲ

Open the dust bag compartment lid

(see Figure 21).

Ⅲ

Release the filter holder by moving the locking lever

in the direction of the arrow.

Ⅲ

Remove the micro-hygiene filter. Insert the new

micro-hygiene filter into the vacuum cleaner.

Ⅲ

Insert the filter holder into the vacuum cleaner and

clip into place.

Replacing the micro active carbon filter

If your vacuum cleaner is equipped with a micro active

carbon filter, this should be replaced every six months.

Figure

Ⅲ

Open the dust bag compartment lid

(see Figure 21).

Ⅲ

Release the filter holder by moving the locking lever

in the direction of the arrow.

Ⅲ

Remove the micro active carbon filter.

Ⅲ

Insert the new micro active carbon filter.

Ⅲ

Insert the filter holder into the vacuum cleaner and

clip into place.

Replacing the HEPA filter

If your vacuum cleaner is equipped with a HEPA filter,

this should be replaced once a year.

Figure

Ⅲ

Open the dust bag compartment lid (see Figure 21).

Ⅲ

Release the Hepa filter by moving the locking lever in

the direction of the arrow and remove it from the

vacuum cleaner.

Ⅲ

Insert the new HEPA filter and clip into place.

If you have used the vacuum cleaner for vacuuming fine

dust particles, clean the motor protection filter and, if

necessary, replace micro hygiene filter, the micro active

carbon filter or Hepa filter.

Care

Always switch off the vacuum cleaner and disconnect

the power cord from the mains before cleaning the

appliance. The vacuum cleaner and plastic accessories

can be cleaned with a commercial plastic cleaner.

Do not use a scourer, glass-cleaning agent or all-

purpose cleaning product. Never immerse the

vacuum cleaner in water.

The dust compartment can, if necessary, be cleaned

with a second vacuum cleaner or simply wiped with a

dry cloth or dusting brush.

Subject to technical modifications.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens VS57E20 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info