This flash unit will automatically calculate and indicate the appropriate Subject Distance according to the
above formula. (Please refer to table1 on the last page)
HIGH SPEED SYNC (FP) FLASH䟺HSS䟻
When you take a picture with an ordinary flash, you cannot use a shutter speed faster than the camera’s
synchronized speed because the flash must fire when the shutter curtain is fully open. The FP flash keeps firing,
while the shutter curtain is running. Thus you can use a shutter speed faster than the synchronized speed.
ۋ This function cannot be used with Maxxum / Dynax ST Si, QT Si,
500si, 400 Si, 300Si, xi series, i series or Vectis series cameras.
1. Choose the Flash Mode by using MODE button (“TTL” or “M” modes
can be used).
2. Press the + or – button and make the indicate
indicator appear
on the LCD panel.
3. Focus on the subject
4. When the Ready Light of the flash is illuminated, the unit is ready for use.
ۋ Depending on the shutter speed, the Guide Number will be changed.(Please refer to table2 on the last
page)
ۋ If you want to cancel the FP Flash mode, please follow the FP flash procedure to make the
indicator
display from the LCD panel.
MODELING FLASH
If you use the Modeling flash, you can check the lighting and shadow effects, before you take the picture.
1. Press the MODE button and select the mode.
2. Press the + button or – button several times to make the icon on the LCD panel appear.
3. Confirm that the flash is charged, then press the TEST button to fire.
MULTI FLASH MODE
While the shutter is open, the flash will fire repeatedly. By doing so a series of images of the subject will be
exposed in one frame. A dark background with a bright subject shows more effectively in this mode. It is
possible to set the firing frequency between 1Hz and 100Hz. Up to 90 flashes can be fired continuously. The
maximum number of flashes varies, depending on the flash guide number and firing frequency settings.
(Please refer to table 3 on the last page)
1.
Set the camera’s exposure mode to M mode, and set the F number
2. Press the MODE button until the Multi-flash mode appears
3.
Press the SEL button until the flash firing frequency starts to blink.
4.
Press the 㸠 or 㸢 button to set the desired flash frequency value.
5.
After pressing the SEL button again, the flash power level will blink.
6. Press the 㸠 or 㸢 button to set the desired power level.
7. Press the SEL button again, the number of flashes will blink.
8. Press the 㸠 or 㸢 button to set the desired number of flashes.
9. Press the SEL button again, the display will stop blinking.
10. When the ready light of the flash is illuminated, the unit is ready to use.
Note: Please set the shutter speed longer than; Number of Flashes you want ¹ Firing Frequency
BOUNCE FLASH
When you take a photo with flash in a room, sometimes a strong
shadow will appear behind the subject, if you point the flash head
upwards or sideways to reflect the light off the ceiling, wall etc. the
subject will be illuminated softly. Press the lock button and adjust the
flash head to set the bounce angle.
UP: 0°, 60°, 75°, 90°
DOWN: 0°,7°
RIGHT: 0°, 60°, 75°, 90r
LEFT: 0°, 60°, 75°,90°, 120°, 150°, 180°
