752909
26
Zoom out
Zoom in
Vorherige Seite
1/85
Nächste Seite
26 GB/IE
Inserting / replacing batteries
Open the battery compartment cover on the
remote control.
Insert two batteries into the battery compartment
or replace the old batteries with new ones. Only
use batteries of the specified type (see „Technical
data“).
Note: When inserting the batteries, be sure to
observe the correct polarity. This is shown in
the battery compartment.
Close the battery compartment cover on the
remote control.
Operation
Due to the complexity of domestic environments the
product may skip some areas when cleaning. For
better cleaning results we recommend using the
product daily.
Preparation
Remove any obstacles prior to use, for example
power cables, toys and other objects.
Tuck rug edges under the rug. Do not allow
curtains and tablecloths to touch the floor.
Try to position furniture properly.
Test the product in areas with stairs. This allows
you to check whether the product can detect
the edge of area which it could fall off.
Do not stand in the way of the product when it
is working. Otherwise the product will be una-
ble to clean these areas.
Cleaning
Press the Clean button on the robot vacuum
cleaner 11 or on the remote control 27 if the
display shows „88:88“. The notification will
switch to AUTO and the product will begin the
cleaning programme. If the product is in Standby
mode, the initial „88:88“ notification will ap-
pear after the Clean button is pressed for the
first time. When the Clean button is pressed for
a second time, the notification switches to
AUTO and the cleaning programme begins.
Note: During automatic cleaning, the product
will switch to Corner mode when necessary, if
it is nearing a corner. After cleaning the corner,
the product will switch back to Normal mode.
To pause the cleaning programme part way
through, press the Clean button on the robot
vacuum cleaner 11 or on the remote control 27 .
To continue the cleaning programme, press the
Clean button on the robot vacuum cleaner 11 or
on the remote control 27 again within 15 sec-
onds. If the pause lasts longer than 15 seconds,
the product will switch to Sleep mode and the
notification in the display 1 will go off.
You can also switch the product to Sleep mode
manually. To do so, hold the Clean button on
the robot vacuum cleaner 11 down for a few
seconds until the notification in the display 1
goes off.
With the product paused, you can use the
directional buttons 26 on the remote control to
manually move it left / right / forwards / back-
wards.
Cleaning modes
For better cleaning results, the product has various
cleaning Modi. You can select the modes by pressing
the buttons on the product or on the remote control.
Spot mode
This mode is suitable for very dirty or very dusty
areas. In Spot mode, the product will focus on one
area to clean.
During cleaning, press the Spot mode button
on the robot vacuum cleaner 14 or the remote
control 29 to start this mode.
As soon as the surface is sufficiently clean, the
product continues with the automatic cleaning
programme.
Note: You can also end Spot mode by pressing
the Clean button once on the robot vacuum
cleaner 11 or on the remote control 27 .
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest IAN 306041 SSR 3000 A1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info