752909
28
Zoom out
Zoom in
Vorherige Seite
1/85
Nächste Seite
28 GB/IE
Close the cover of the dust collector 22 , making
sure that it audibly clicks into place, and insert
the dust collector 21 back into the product.
Close the cover 10 of the product, making sure
it audibly clicks into place.
Cleaning the brushes
Regularly remove any hair and dirt from the
side brushes 17 .
Cleaning the main housing
Clean the 3 anti-fall sensors 18 to maintain
their sensitivity.
Clean the front wheel 19 to remove any hair
tangled in it.
Clean the anti-collision sensor 20 to maintain
its sensitivity.
Replacing parts
Replacing the side brushes
If the side brushes 17 are worn out, they can be
replaced with the supplied replacement side
brushes 6.
Loosen the old side brushes 17 fixed to the
underside using a cross-tip screwdriver (not
included in the delivery contents).
Screw the replacement side brushes 6 into
place.
Replacing the HEPA filter
Depending on the frequency of use, the HEPA filter
5 should be cleaned after approx. 15 to 30 days.
After approx. 6 months it should be replaced with
the supplied replacement filter.
Remove the old HEPA filter 5 (see chapter
„Cleaning and storage“).
Insert the new HEPA filter 5.
Troubleshooting /
Problem solving
If the product is not working correctly, the display
1 will show various error codes and emit signal
tones of different lengths. Please refer to the table
below for troubleshooting.
After troubleshooting, press the Clean button on the
robot vacuum cleaner 11 or on the remote control 27 .
Problem Possible
cause
Trouble-
shooting
No function. Battery is not
fully charged. Charge the
battery fully.
Power switch
9 switched to
O”.
Switch the
power switch
9 to “I”.
Battery contacts
are dirty. Clean the
charging con-
tacts 3 and
the battery
contacts on
the product.
Poor suction
power.. Suction vent 16
is blocked.
Check the suc-
tion vent 16 .
Dust collector
21 is full or the
filters 5, 23
are blocked.
Proceed as
described in
the chapter
“Cleaning and
storage”.
Error code Possible
cause
Possible
trouble-
shooting
E01 Left side wheel
does not turn. Check the left
side wheel
and clean it if
necessary.
E02 Right side
wheel does not
turn.
Check the right
side wheel
and clean it if
necessary.
E04 Product was
lifted up Place the
product back
on the floor
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest IAN 306041 SSR 3000 A1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info