Bedienungsanleitung Silvercrest IAN 63708 (Seite 22 von 32) (Englisch, Portugiesisch, Spanisch)

738597

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

26 GB/MT

Safety advice / Preparing for use

J Remove a spent battery immediately from the

device. There is an increased danger of leaks!

J Batteries must not be disposed of in the normal

domestic waste!

J Every consumer is legally obliged to dispose of

batteries in the proper manner!

J Keep batteries away from children; do not

throw them in the ﬁre, short-circuit them or take

them apart.

J If the above instructions are not complied with,

the battery may discharge itself beyond its end

voltage. There is then a danger of leaking. If

the battery has leaked inside your device, you

should remove it immediately in order to

prevent damage to the device!

Preparing for use

Remove the battery

insulation strips

j Slide open the battery compartment cover

and take it oﬀ the battery compartment

j Remove the battery insulation strip.

j Close the battery compartment

with the

battery compartment cover

j Note: Follow the instructions for inserting the

battery as described in the section on “Replac-

ing the battery”.

Setting the units of weight

Note: the standard unit of weight is kilogram (kg).

The factory default setting for the scales as supplied

is “kg”.

j With the device switched on, press the units of

weight button

(KG/LB/ST); the selected unit

of weight is then shown on the LC display

kilogram (kg), pound (lb), stone (st)

Switching on your scales /

measuring your weight

Tip: Weigh yourself at the same time of day

(preferably in the morning) after visiting the

toilet, with an empty stomach and without cloth-

ing to ensure that your results are compatible.

j Place the scales down on a solid, ﬂat horizontal

surface.

j Do not place the scales on a carpet, otherwise

this may inﬂuence the results. If necessary you

can place a board on the carpet and place the

scales upon this. A solid ﬂoor covering is required

in order to achieve correct weight measurements.

Quickstart / AUTO ON

j Stepping on the scale automatically activates

the Quickstart mode: The scale is now ready to

measure your weight.

j Place even weight on each leg.

j If at all possible stand on the same areas of the

platform

each time and do not move. Mov-

ing during the weighing process can lead to

discrepancies in the results.

The scales will start to measure immediately. The

scale shows the result of the measurement, for

example in Fig. A.

j When the unit of weight ﬂashes twice, the

measurement is complete.

Note: If the scales show “

” (see Fig. C), it

signals that the scales are overloaded. Observe

the maximum capacity of 180 kg / 396 lbs / 28 st.

j Step oﬀ the platform

. The scales switch oﬀ

automatically after about 10 seconds.

Replacing the battery

Note: The scale indicates when it is time to replace

the battery. When you step on to the scale and the

battery is too weak, the LC display

shows “ ”

(see Fig. B) and the scale switches oﬀ automatically.

j If you see this message, replace the exhausted

battery with a new battery of the same type.

j Follow these steps:

63708_silv_Waage_content_LB5.indd 26 08.02.11 15:16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest IAN 63708 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest IAN 63708

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info