Bedienungsanleitung Silvercrest Z31281 - IAN 75609 (Seite 9 von 45) (Deutsch, Englisch, Dänisch, Schwedisch, Finnisch)

575343

Zoom out

Zoom in

Vorherige Seite

1/45

Nächste Seite

9 GB/IE

Operation

Note: In the weighing mode settings for

water and milk, the device displays the vol-

ume (ml / ﬂoz) of the liquid in the bowl. This

function is intended to replace the use of a

measuring jug for liquids. Please note that

in particular the volume of milk depends on

the fat content, the origin of the milk and

other factors. The volume displayed there-

fore corresponds to an average value.

j You can press the Digital timer / UNIT /

Alarm / - button

to switch between the

displayed units

. The following units

can be used in the measurements:

Weight: Gram (default setting), oz, lb

Water: ml (default setting), ﬂoz

Milk: ml (default setting), ﬂoz

Note: The measurement unit oz (ounce) is

still in common use for foods and is the

equivalent of approx. 28.35 g. The meas-

urement unit lb (libra = Latin for pound) is

the equivalent of approx. 453.59 g and

equals 16 oz. The measurement unit ﬂoz

(ﬂuid ounce) is the equivalent of approx.

28.4 ml. 100 ml is therefore the equivalent

of approx. 3.5 ﬂoz.

Weighing out foods:

Note: When you are weighing heavy items,

place them slowly and carefully on to the

weighing bowl

to avoid damaging the kitch-

en scale.

1. Place an ingredient into the weighing bowl

. The weight is immediately shown in the

display.

2. Press the TARE button

to zero reset the

display. The display shows “0” and the tare

indicator

will light up.

3. Now add the desired quantity of the second

ingredient. You can read the added quantity

directly in the display.

4. Repeat steps 2 and 3 until all the required

ingredients have been added.

5 kg

Note that the maximum load on

the scale is 5 kg.

Note: If the scale is overloaded, then the

display shows “ ”.

Note: If no button is pressed within a period

of two minutes, the kitchen scale’s display

automatically shows the time.

Using the temperature

display

j Press the MODE / + button

until the

device enters the temperature mode. This

comes after the weighing mode.

j Temperature measurement is carried out at

an interval of approximately 10 seconds.

j You can press the Digital timer / UNIT /

Alarm / - button

to switch the indicator

between °C and °F.

Note: If no button is pressed within a period

of two minutes, the kitchen scale’s display

automatically shows the time.

Using the alarm function

j Press the MODE / + button

until the

device enters the alarm mode. This comes

after the temperature display.

j Press the SET / WEIGHT MODE button

to enter the settings mode. The minute value

ﬂashes.

j You can use the MODE / + button

or the

Digital timer / UNIT / Alarm / - button

set the value.

j Press the SET / WEIGHT MODE button

to store the set value and move on to setting

the hours. The hour value ﬂashes.

j You can use the MODE / + button

or the

Digital timer / UNIT / Alarm / - button

set the value.

j Press the SET / WEIGHT MODE button

to store the set value and leave the settings

mode.

Note: If no key is pressed within 10 seconds,

the set value will stop ﬂashing and the alarm

time is set to the value shown in the display.

75609 CB3_GB_DK.indd 9 7/5/2012 8:47:32 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest Z31281 - IAN 75609 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest Z31281 - IAN 75609

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info