Bedienungsanleitung Skoda Rapid - 2013 (Seite 179 von 218) (Englisch)

678345

179

Zoom out

Zoom in

Vorherige Seite

1/218

Nächste Seite

WARNING

■

The factory-supplied lifting jack is only intended for your model of vehicle.

Under no circumstances use it to lift heavier vehicles or other loads – risk of

injury!

■

Ensure that the vehicle tool kit is safely secured in the boot.

■

Ensure that the box is always secured with the strap.



Changing a wheel



Introduction

This chapter contains information on the following subjects:

Preliminary work

177

Changing a wheel

178

Follow-up work 178

Loosening/tightening wheel bolts

178

Raising the vehicle 179

Securing wheels against theft

179

WARNING

■

If you are in flowing traffic, switch on the hazard warning light system and

set up the warning triangle at the prescribed distance! The national legal re-

quirements must be observed.

■

Park the vehicle as far away as possible from the flow of traffic. Park on as

flat and firm a surface as possible.

■

The following instructions must be followed if the vehicle is subsequently

fitted with tyres or rims that differ from the factory-fitted ones » page 170,

New tyres.

WARNING

Observe the following instructions for lifting the vehicle.

■

If the wheel has to be changed on a slope, first of all block the opposite

wheel with a stone or similar object to prevent the vehicle from unexpectedly

rolling away.

■

Secure the base plate of the lifting jack with suitable means to prevent pos-

sible moving. A soft and slippery ground under the base plate may move the

lifting jack, causing the vehicle to fall down. It is therefore always necessary to

place the lifting jack on a solid surface or use a wide and stable base. Use a

non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled

stones, tiled floor, etc.

■

Only attach the lifting jack to the attachment points provided for this pur-

pose.

■

Always raise the vehicle with the doors closed.

■

Never position any body parts, such as arms or legs under the vehicle, while

the vehicle is raised with a lifting jack.

■

Never start the engine when the vehicle is raised – risk of injury.

CAUTION

■

The prescribed tightening torque of the wheel bolts for steel and light alloy

wheels is 120 Nm.

■

If the wheel bolts are fastened too tightly, this can cause damage to the anti-

theft wheel bolt or the adapter.

Note

The national legal requirements must be observed when changing a wheel.



Preliminary work

First read and observe the introductory information and safety warn-

ings on page 177.

Always change a wheel on a level surface as far as possible.

The following steps must be carried out before actually changing the wheel:

›

Let all of the occupants get out. While changing a tyre, the occupants of the

vehicle should not stand on the road (instead they should remain behind a crash

barrier).





177

Emergency equipment and self-help

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid - 2013 Seite 179

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid - 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info