Bedienungsanleitung Skoda Rapid - 2015 (Seite 160 von 200) (Englisch)

617604

160

Zoom out

Zoom in

Vorherige Seite

1/200

Nächste Seite

Raising the vehicle 159

Anti-theft wheel bolts 160

For your own safety and the safety of the passengers, the following instruc-

tions must be observed before changing a wheel on the road.

Switch on the hazard warning lights system.

The warning triangle must be set up at the prescribed distance - observe

the national legal provisions when doing so.

Park the vehicle as far away as possible from the flow of traffic.

Choose a location with a flat, solid surface.

Have all the occupants get out. The passengers should not stand on the

road (instead they should remain behind a crash barrier, for instance) while

the wheel is being changed.

The following instructions must be followed if the vehicle is subsequently fit-

ted with tyres or rims that differ from the factory-fitted ones » page 151, Ex-

planation of the tyre labelling.

The national legal requirements must be observed when changing a wheel.

Preliminary work

Before changing the wheel, the following work must be carried out.

›

Switch off the engine.

›

Engage the 1st gear or place the selector lever of the automatic transmission

in the P-position.

›

Firmly apply the handbrake.

›

Uncouple any trailers.

›

Remove the vehicle tool kit » page 155 and the spare wheel » page 155 from

the boot.

Full wheel trim

Before removing the wheel bolts, remove the wheel cover.

Extracting

›

Hook the clamp found in the vehicle tool kit » page 155 into the reinforced

edge of the wheel trim.

›

Push the wheel wrench through the clamp, support on the tyre and pull off

the wheel trim.



Installing

›

Press the wheel trim onto the wheel rim at the designated valve open-

ing » .

›

Then press the trim into the wheel rim until its entire circumference locks

correctly in place.

CAUTION

Notes from the factory or from the ŠKODA Original accessory delivered trim..

■

When using an anti-theft wheel bolt, make sure that this has been fitted ac-

cording to the position marked on the back of the wheel cover position.

■

On the back of the wheel cover, the position for the anti-theft wheel bolt is

marked by means of a symbol. If the wheel cover is set outside the position

marked for the anti-theft wheel bolt, there is a risk of damaging the wheel

cover.

CAUTION

■

Use the pressure of your hand only, do not strike the full wheel trim. The

cover could be damaged.

■

If wheel trims are fitted, an adequate flow of air must be assured in order to

cool the brake system.

Note

We recommend that you use wheel trims from ŠKODA Original Accessories.

Wheel bolts

Fig. 132

Remove the cap

Before removing the wheel bolts, remove the covering caps.

Extracting

›

Push the extraction pliers » page 155 sufficiently far onto the cap until the

inner catches of the pliers are positioned at the collar of the cap.

›

Remove the cap in the direction of the arrow » Fig. 132.



157

Emergency equipment and self-help

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid - 2015 Seite 160

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid - 2015

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info