678360
247
Zoom out
Zoom in
Vorherige Seite
1/294
Nächste Seite
Breakdown assistance246
Never start the engine with the vehicle sitting on the raised jack - danger
of suffering injury!
Caution
If you have to change a wheel on a slope first block the opposite wheel with a stone
or similar object in order to secure the vehicle from unexpectedly rolling away.
Note
Comply with the national legal regulations.
Changing a wheel
Always change a wheel on a level surface as far as possible.
Take off the full wheel trim* page 247 or the caps page 247.
In the case of light alloy wheels remove the wheel trim cap
page 248.
First of all slacken the safety wheel bolt * and afterwards the other
wheel bolts page 248.
Jack up the vehicle until the wheel to be changed is clear of the ground
page 249.
Unscrew the wheel bolts and place them on a clean surface (cloth,
paper etc.).
Take off the wheel.
Fit on the spare wheel and tighten the wheel bolts slightly.
–Lower the car.
Tighten the wheel bolts firmly, alternately and diagonally using the
wheel wrench (crosswise) and last the safety wheel bolt* page 248.
Mount the full wheel trim/wheel trim cap or the caps.
Note
All bolts must be clean and must turn easily.
You must never grease or oil the wheel bolts!
When fitting on unidirectional tyres, ensure that the tyres rotate in the correct
direction page 235.
Subsequent steps
After changing the wheel, you must perform the following steps.
Stow and attach the replaced wheel in the spare wheel well using a
special screw page 245, fig. 216.
Stow the vehicle tool kit in the space provided.
Check the tyre pressure on the spare wheel just mounted as soon as
possible.
Have the tightening torque of the wheel bolts checked with a torque
wrench as soon as possible. Steel and light alloy wheels must be tight-
ened to a tightening torque of 120 Nm.
Have the defective tyre repaired as soon as possible.
WARNING
It is necessary to observe the guidelines given on page 237 if the vehicle is
subsequently fitted with tyres which are different to those it was fitted with
at the works.
WARNING (continued)
s2dk.1.book Page 246 Wednesday, April 8, 2009 12:23 PM
247

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Skoda Superb - 2009 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Skoda Superb - 2009

Skoda Superb - 2009 Bedienungsanleitung - Deutsch - 302 seiten

Skoda Superb - 2009 Bedienungsanleitung - Holländisch - 304 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info