Bedienungsanleitung Skoda Superb - 2010 (Seite 242 von 287) (Englisch)

678359

242

Zoom out

Zoom in

Vorherige Seite

1/287

Nächste Seite

Breakdown assistance 241

Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data

The safety wheel bolts on vehicles fitted with them (one safety wheel bolt per wheel)

can only be loosened or tighten up by using the adapter provided.

It is meaningful to note the code number hammered into the rear side of the adapter

or the rear side of the safety wheel bolts. You can obtain a replacement adapter from

an authorised Škoda Service Partner, if necessary, by quoting this number.

We recommend that you always carry the adapter for the wheel bolts with you in the

vehicle. It should be stowed in the vehicle tool kit.

Caution

Damage can occur to the adapter and safety wheel bolt if the safety wheel bolt is tight-

ened up too much.

Note

The set of safety wheel bolts can be obtained from an authorised Škoda Service

Partner.

Jump-starting

Initial steps

You can use the battery of another vehicle for jump-starting yours if the engine does

not start because the battery on your vehicle is flat. You will require jump-start cables

for this purpose.

Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the battery

supplying the power must not be significantly less than the capacity of the discharged

battery in your vehicle.

Jump-start cables

Only use jump-start cables which have an adequately large cross-section and insu-

lated terminal clamps. Please pay attention to the manufacturer's instructions.

Positive cable - colour coding in the majority of cases red.

Negative cable - colour coding in the majority of cases black.

WARNING

 A discharged battery may already freeze at temperatures just below 0°C. In

case of frozen battery carry out no jump-starting - risk of explosion!

 Please pay attention to the warning instructions relating to working in the

engine compartment  page 216, “Working in the engine compartment”.

Note

 There must not be any contact between the two vehicles otherwise current may

flow as soon as the negative terminals are connected.

 The discharged battery must be properly connected to the system of the vehicle.

 Switch off any mobile phone, pay attention to the instructions for use of the mobile

phone in such a situation.

 We recommend that you purchase the jump-starting cable in the specialist shops

of the battery manufacturers.

Start engine

It is important to connect the jump-start cables in the correct order.

Connecting positive terminals

–Attach one end  fig. 201 to the positive terminal of the discharged battery

 fig. 201.

Fig. 201 Jump-starting using the

battery from another vehicle: A - flat

vehicle battery, B - battery providing

current

s3fg.2.book Page 241 Friday, April 30, 2010 12:17 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Superb - 2010 Seite 242

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Superb - 2010

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info