Bedienungsanleitung Skoda Superb - 2010 (Seite 243 von 287) (Englisch)

678359

243

Zoom out

Zoom in

Vorherige Seite

1/287

Nächste Seite

Breakdown assistance242

– Attach the other end to the positive terminal of the battery supplying the power

Connecting negative terminal and engine block

– Attach one end to the negative terminal of the battery supplying the power .

– Attach the other end to a solid metal part which is connected firmly to the

engine block, or to the engine block itself.

Starting the engine

– Start the engine of the vehicle providing current and run the engine at idling speed.

– Now start the engine of the vehicle with the discharged battery.

– Interrupt the attempt at starting an engine after 10 seconds if it does not start right

away and wait for about 30 seconds before repeating the attempt.

– Disconnect the cables on the engine in exactly the reverse order they were

connected up.

WARNING

 The non-insulated parts of the terminal clamps must never make contact

with each other. Furthermore, the cable connected to the positive terminal of

the battery must not come into contact with electrically conducting parts of the

vehicle - risk of a short circuit!

 Do not affix the jump starting cables to the negative terminal of the

discharged battery. There is the risk of detonating gas seeping out the battery

being ignited by the strong spark which results from the engine being started.

 Run the jump-start cables so that they cannot be caught by any rotating

parts in the engine compartment.

 Do not bend over the batteries - risk of caustic burns!

 The vent screws of the battery cells must be tightened firmly.

 Keep any sources of ignition (naked flame, smouldering cigarettes etc.)

away from the battery - risk of an explosion!

 Never jump-start the batteries which have a too low electrolyte level - risk

of explosion and caustic burns.

Jump-starting on vehicles with jump-starting point

For vehicles with the 3.6 ltr./191 kW FSI engines, the positive terminal of the battery

supplying the power can only be connected to the jump-starting point in the engine

compartment of the vehicle which must be started by means of a jump-starting

cable fig. 202!

– Open the protective cap of the jump-starting point in direction of arrow.

– Connect the positive terminal of the battery supplying the power with the jump-

starting point.

– Attach the negative terminal of the battery supplying the power to a solid metal

part which is connected firmly to the engine block or to the engine block itself.

–Start the engine  page 242.

– After the engine start, close the protective cap of the jump-starting point.

Tow-starting and towing vehicle

General

Please pay attention to the following instructions if you are going to use a tow rope:

Driver of the towing vehicle

– Do not drive off until the tow rope is taught.

Fig. 202 Detail of the engine compart-

ment: Jump-starting point

s3fg.2.book Page 242 Friday, April 30, 2010 12:17 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Superb - 2010 Seite 243

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Superb - 2010

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info