Bedienungsanleitung Smoov One O10 (Seite 10 von 37) (Englisch)

785804

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

2.1 Attaching the drive unit to the wheelchair

With a little practice, active wheelchair users can attach the drive unit of the SMOOV O10

themselves while sitting in the wheelchair. Alternatively, the drive unit can be attached

to the wheelchair before the wheelchair user takes their seat. A helper may also attach

the drive unit.

When attaching the unit, proceed (or have a helper) proceed as follows:

•Apply the parking brakes to prevent your wheelchair from rolling away inadvertently.

•Ensure that both the drive unit and the control unit are switched off. Both compon-

ents may only be attached to the wheelchair if they are switched off.

•Hold the drive unit by its handle [4] and slide it under the wheelchair, as lifting the

drive unit could cause the wheelchair to tip backwards!

•Lift the drive unit by its handle [4]. This causes the locking claw [9] to open automat-

ically.

•Insert the locking claw [9] into the bracket or adapter axle [22] on the wheelchair and

let go of the handle [4].

•If the locking claw [9] and the bracket or adapter axle [22] are connected to each

other correctly, the handle [4] lowers to its resting position automatically.

•In addition, check that the drive unit is correctly connected to the wheelchair by gently

moving the housing. In this regard, the drive unit must never be held or lifted by the

handle [4], as this will undo the connection. The drive unit must also not be held in

areas close to the drive wheel [8]. This is to prevent fingers being trapped by the hori-

zontally rotating drive wheel, for example.

In these few steps, you have attached the drive unit to your wheelchair. Now it is time to

install the control unit.

Please be aware that lifting the drive unit by the handle [4] opens

the locking claw [9] and the connection with the bracket or adapter

axle [22] is undone as a result!

Apply the parking brakes to prevent your wheelchair from rolling away

inadvertently.

Make sure that the drive unit is switched off. The device may only be

attached to the wheelchair if it is switched off.

2.2 Removing the drive unit from the wheelchair

Active wheelchair users (or a helper) may also remove the SMOOV O10 themselves.

•Apply the parking brakes to prevent your wheelchair from rolling away inadvertently.

•Ensure that both the drive unit and the control unit are switched off. Both components

may only be removed from the wheelchair if they are switched off.

•Lift the drive unit by its handle [4]. This causes the locking claw [9] to open automat-

ically.

•Remove the drive unit from the bracket or adapter axle [22]. Slide the drive unit

under the wheelchair, as lifting the drive unit could cause the wheelchair to tip back-

wards!

•Put the drive unit down in a safe place where misuse of the device (e.g. due to chil-

dren playing) is ruled out.

Apply the parking brakes to prevent your wheelchair from rolling away

inadvertently.

Make sure that the drive unit is switched off. The device may only be

removed from the wheelchair if it is switched off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smoov One O10 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smoov One O10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info